8034 Snapper - Parts

This is a genuine Murray and Snapper part sourced directly from the manufacturer for use in lawn mowers. The right hand lower handle is made out of durable materials. When replacing this item a socket set and a wrench set might be required during the installation process. It will need to be replaced if it breaks. This part is available individually.

This is a genuine Murray and Snapper replacement part for use in lawn mowers and lawn tractors. The cap screw attaches to the idler pulley. A wrench may be needed during the replacement of this part. It is made out of metal and will need to be replaced if it strips or breaks. This item is sold individually.

It is an authentic OEM item that is designed for use with a variety of lawn and garden equipment. A washer is a special part which helps to provide a tight fit between connected components. This part provides an identical replacement for a damaged or a missing hardware that was installed on a new unit. It is a standard hardware which may ...Read morehave multiple applications. Make sure to check the appropriate diagrams for your specific model for the exact location and the correct application of this cone washer. Note, it is made of durable metal and is sold individually.

This is an authentic Snapper replacement part, sourced from the original manufacturer for use with lawnmowers. The special gasket is commonly used to seal the connection between the two halves of the gearcase housing assembly. This gasket housing is available as an individual replacement part, please see model diagram for associative parts.

This is a genuine replacement part manufactured for use with outdoor power equipment. The special nut is used with a variety of types of equipment and the application of the nut varies depending on the model of equipment. This nut is available as an individual replacement part, please see model diagram for the nut\'s location and usage.

It is an authentic OEM sourced item which is specially produced for use with snowthrowers, generators, and rear engine riders made by Murray, Briggs & Stratton, Snapper, and Simplicity. The nut is made of metal and attaches to the starter switch. During replacement, it may require a wrench to help install this part correctly. It may becom...Read moree broken or stripped and will need to be replaced. This part is available as an individual replacement.

The retainer attaches to the idler arm support. This genuine item is supplied by the original equipment manufacturer for use with tractors and rear engine riders made by Snapper, Murray, and Simplicity. It is made out of metal and is sold individually. During the installation process, a wrench set might be needed to replace this part. Over time this part may break and will need to be replaced.

Spacer 1.0 od x.640

This is a genuine part which is supplied directly by the original equipment manufacturer and is used with Snapper lawn mowers. The wheels allow you to easily propel your mower from place to place. This part is made out of plastic and rubber and is also sold individually. Before installation, make sure the engine has cooled, and disconnect...Read more the wire and boot from the spark plug. For installation, you will need a socket wrench.

This is a genuine OEM supplied replacement part which is specially designed for use with Snapper walk behind lawn mowers. The operator presence control cable stops the blade when the control handle is released, if the cable is broken it will cause the brake to not release even when the lever is pressed. Please note this high-quality rubber insulated component is sold individually.

This is a genuine OEM part. The clutch pull cable is composed of metal, wiring and plastic, and is made for use with many lawn mowers. The cable is fastened to the clutch handle and the clutch spring, allowing the operator to control the mower clutch. This item is sold individually. A pair of pliers and an adjustable wrench are helpful with making the replacement.