8031 - Parts

This motor works with the belt to drive your dryer's drum.

This dryer side vent kit lets you vent the exhaust to the side or bottom of your dryer instead of the default rear position. Included in the kit are 2 straight aluminum foil outlet ducts, each 4 inches wide, along with 1 duct elbow, 1 cover plate, 1 screw, and an instruction sheet. This is helpful for flexible installation in areas where ...Read morerear venting is not possible or practical. All parts are genuine replacements from their original manufacturer.

This is a round, inline fuel filter with 0.25-inch nipples, used in a variety of lawn and garden equipment. It is sourced from the original equipment manufacturer and has the capability to filter out particles as small as 150 microns in size. The filter is designed to remove any dirt or debris in the fuel to avoid contaminating the engine...Read more. Over time, it is common for the filter to become clogged with dirt/debris or damaged, resulting in less fuel entering the engine, engine misfiring, stalling, and overall lower performance from your equipment. To replace the faulty fuel filter, first disconnect the fuel lines with pliers or a clamp tool and then pull out the old filter. Install the new filter into the housing and reattach the fuel lines to complete your repair.

Restore smooth, efficient drying with this durable drum tub assembly, designed to keep your LG dryer performing at its best. This complete assembly houses the inner and outer drums, ensuring proper tumbling, even heat distribution, and optimal airflow for faster, more consistent drying. Built to reduce noise and vibration, it helps mainta...Read morein a quiet laundry experience while preventing damage to fabrics. The assembly typically includes felt seals for a secure fit. Installation is straightforward—disconnect the power, remove the old drum, and position the new assembly using basic tools.

This assembly is the tub, felt seal and 3 baffles in the tub.

This rewind starter spring or as it is also known, recoil spring, rewinds the pull robe back into the starter housing of your engine. The spring is made of metal, silver colored, and sold individually. Over time, you may notice that you are having trouble retracting your pull cord, which could be a symptom of the rewind starter spring f...Read moreailing due to fatigue or wear. Replacing this part is a repair our customers found easy. Locate and replace the start spring inside the starter housing; no special tools are required for this job.

This is a Genuine OEM replacement part used on a variety of Lawn and Garden equipment. The key helps to secure Flywheel in place. This is a Metal Key and it is Sold Individually. You would need Pliers to replace this item.

This moisture sensor wire harness connects the sensor bars to the dryer’s control board, enabling accurate detection of fabric dampness to prevent over-drying and improve energy efficiency. Designed for a precise fit, this single harness ensures proper communication between the sensors and the control system, restoring optimal drying perf...Read moreormance when the original part fails. Common signs of failure include clothes remaining too wet or becoming over-dried. For safety, disconnect power before installation and follow manufacturer guidelines.

This grey drying rack fits inside your front load dryer. It is an accessory used to dry items that should not tumble, like shoes, stuffed animals, pillows, or other delicate items. It provides a stationary surface for these items to rest on while air circulates. The rack is 27 inches wide and can be attached inside the dryer drum. This genuine OEM rack is sold individually.