8018 - Parts

This is a genuine item that is supplied by the original equipment manufacturer for use with Murray and Snapper lawn and garden equipment. It is an identical replacement for a missing or a faulty lever that was installed on a new unit, please make sure to refer to the appropriate diagram of your model for the correct location and applicati...Read moreon of this component. This high-quality item is made of durable plastic and is sold individually, keep in mind the hardware to secure it is sold separately.

Pin 5/16-x1.68

This brush insert is an OEM direct from DeWALT. The metal, brush insert is compatible with many mulch mowers. Secured onto the brush spring and terminal, this part has been designed to move electricity to the motor's armature. This part is sold individually. A screwdriver is helpful in the removal and repair.

This rectifier is an original part from Black and Decker. Composed of metal and plastic parts, the rectifier is compatible with a variety of tools and machines. This component the electric current fro AC to DC voltage. It is encouraged to refer to the specific manual and diagrams for repair instructions. This part is sold individually. A screwdriver is often helpful in making the replacement.

This is a genuine replacement part sourced directly from the manufacturer. The screw is commonly found in lawn tractors from Murray and Snapper. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different screws used in the machine. Refer to the parts d...Read moreiagram to be sure of ordering the correct part. You will require a wrench when replacing this item. The screw is sold as an individual replacement part.

This authentic item is supplied directly from the original equipment manufacturer for use with DeWALT and Black and Decker lawn mowers. The purpose of a terminal is to allow a user to easily connect a wire. It provides an identical replacement for a missing or a faulty terminal that was installed on a new unit. Please make sure to check t...Read morehe appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality part is made of durable metal and is sold individually.

Genuine Black and Decker replacement part, this item is sold individually. When this lever is pulled it makes contact with the Push button switch. At this point the electric motor will start, and the mower blade will begin to rotate. This lever is used on all of the mowers shown below.

The ignition switch attaches to the internal lockwasher and the hex nut. It is an OEM replacement part for use in lawn tractors made by Snapper, Murray, and Simplicity. This part is available individually and is made of metal. A wrench may be required to replace this part if it becomes broken.

This is an authentic Black and Decker replacement part that has been sourced from the original manufacturer to be used with electric lawnmowers. The metal spring is used with the brush holder assembly and fits into the end cap to keep the carbon brushes pressed against the motor's armature. This item is priced as a single item, please note two may be required.

Retaining ring ext

Genuine Waring replacement part, this item is sold individually. This part acts as a seal for the blenders shown below. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these seals and washers will become brittle and compressed, then will have to be replaced.

Solenoid starter