7KSM180LEZLB0 KitchenAid Mixer - Parts

This part is a retaining ring, sometimes called a retaining clip, that holds the drum support roller onto the shaft of a dryer. It is made entirely of metal and measures less than an inch in diameter. The retaining ring is a genuine OEM part sourced directly from the manufacturer. The ring may vary in appearance due to manufacturer substi...Read moretution, but the function is the same. You may need to replace this part if the dryer is noisy during tumbling, will not tumble, or takes too long to dry. Be sure to check drum support roller kit and shaft before ordering parts.

Used on Stand Mixers. Sold Individually.

This worm gear is an inch and a half in diameter. It is used for some of Whirlpool's brands of mixers.

Sold individually.

Used for Kitchenaid Mixers.

Used in Mixers.

This part works in conjunction with the worm and bevel gear.

Use with stand mixers. Screws are not included. Cap only.

Use with stand mixers.

Used on Stand Mixers.

This speed governor, or clutch, can typically be found in your tilt-head or bowl-lift mixers beside the control plate. It is one of the three parts that work together to regulate and control the mixing speed. If you notice speed fluctuations or unresponsiveness to adjustments, the speed governor may be malfunctioning. To replace it, consu...Read morelt your user manual for instructions. Start by disconnecting the mixer from its power source and removing the beater and bowl. Take off the rear cover and unscrew the mounting screws from the trim to remove it. Disconnect the wires on the control plate and pry the end seal from the appliance. Remove the fasteners on the control plate to access the governor, which can be wiggled off the shaft using pliers. Please be aware that this OEM part is sold individually.

Used on Stand Mixers.