7C01A Magic Chef Refrigerator - Parts

NOTE: This is now the single lamp kit socket. The dual lamp kit socket is no longer available.

This door hinge washer is less than an inch in diameter. It is all white in color and it is made entirely of plastic.

The bushing is made of white plastic and is for a 3/8-inch pin. This bushing is part of your refrigerator assembly and is found on the top of the door. A worn-out bushing will cause your door to become misaligned. If you notice the fridge door is not opening or closing easily it could be due to the bushing being damaged. You will need to ...Read moreremove the entire refrigerator door by removing the upper hinge first. This will give you access to the bushing. This is a genuine OEM part that comes right from the manufacturer.

This drier may also be known as a refrigerator ultra-violet dye drier or a filter drier and is meant to be used with your fridge. This piece is a filter for the refrigerant that moves through the refrigerators sealed-system. The most common reason you will need to replace the filter is if your fridge/freezer is not starting. You should co...Read morensider having this piece installed by an appliance repair technician that is trained and licensed. Installing this part requires specialized knowledge and tools. The installation will require the service technician to recover and recharge the refrigerant in the refrigerators sealed-system.

Sold Individually. This screw holds the handle in place on the freezer door.

A zip tie, also known as a cable tie or a wire tie, is a fastening device that holds wires or tubing together. If a machine has wires or tubing that are easily shifted, you need to hold them tightly together using a zip tie. It is a flexible, plastic strip that has serrated teeth and a locking mechanism. If the zip tie is damaged, it shou...Read moreld be replaced. Freely moving wires may rub against surfaces, causing them to break over time. Zip ties are single-use and may not be reused after they are removed from a machine. To release the locking mechanism, you will need to insert a small flat tool into the head of the zip tie, between the tongue and the serration, and depress the bar. You can then pull the teeth out of the mechanism to loosen the cable tie. This part is produced by the original equipment manufacturer and is sold individually.

The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed.