79579014901 Kenmore Freezer - Parts

This refrigerator water filter is designed to improve the taste and odor of both water and ice by reducing a wide range of contaminants. Utilizing an activated carbon block filtration method, it effectively captures impurities such as lead, chlorine, mercury, cysts, asbestos, and particulates, while allowing fluoride to pass through. The ...Read morefilter is certified to meet NSF/ANSI Standards 42 and 53 for water purification, ensuring reliable performance and safety. With a lifespan of approximately six months or 300 gallons—depending on water quality and usage—it provides consistent filtration and supports the overall efficiency of your refrigerator’s water system.

The door stop, or door stopper, is used in refrigerators. This door stop helps keep the door in position and in balance. This part is attached to the bottom of the door and it keeps it from opening and hitting the side of the refrigerator cabinet. If you find your door hits and scratches your lower cabinet when you open your fridge door, ...Read moreinstalling this part can be a solution to this problem. Make sure to unplug your appliance from the power source before installing this part and safely store food to prevent it from deteriorating. Refer to the diagram provided by the manufacturer for further instruction.

This refrigerator door hinge bushing is a durable white plastic component that provides a smooth pivot point for the hinge pin, helping keep the door properly aligned and sealed. It is commonly used to correct doors that sag, make noise, or are difficult to open or close due to a worn or damaged bushing. The bushing installs at the door h...Read moreinge pivot point and typically requires removing the hinge bracket with a 10?mm socket. Color is white, and size and dimensions may vary by refrigerator model.

This door stopper helps limit door movement to prevent overextension. Designed for durability and precise positioning, it supports controlled operation and long-term reliability.

When a compressor cannot start, the refrigerator may hum, click, run only briefly, or remain too warm. A start relay with a heat-sensitive resistor controls current to the compressors starting circuit. The assembly may need replacement if its housing is cracked, scorched, loose, or rattles from broken material inside. These signs are help...Read moreful, but electrical tests and the appliance service information should guide the diagnosis. Verify the exact model before ordering because terminal layouts can vary. Disconnect power, allow the compressor area to cool, and discharge any capacitor if equipped and directed. Do not bend the compressor pins, and reinstall the protective cover before operation.

This ice maker assembly is a genuine OEM replacement unit for LG refrigerators. It is responsible for producing and dispensing ice cubes. You can find the ice maker assembly inside the freezer compartment of your fridge. The assembly consists of several parts, including a water inlet valve, ice mold, thermostat, and motorized assembly for...Read more dispensing ice. If any of these components fail, your ice maker will be unable to produce any ice or may only release small amounts of ice. This complete assembly contains all the parts you need to replace your faulty unit and restore your refrigerator.

This water tubing clip holds the water fill tube in place in your refrigerator. The water fill tube attaches and supplies water to the ice maker/water dispenser in your fridge-freezer. If the tubing is in working order, but is hanging loose inside the unit, the issue could be that the clip meant to hold it in place is broken. If this is t...Read morehe case, you should look to replace the clip. This clip is made of black plastic, and is just over half an inch long. This is a genuine OEM replacement part, and is sold separately.