7957901 Kenmore - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
drawer was broken and replaced it
2 of 5 people
found this instruction helpful.
-
Ilene from Lincoln, NE
- Really Easy
- Less than 15 mins
Just put the drawer in and it was ready to go. Like those kind of repairs
Was this helpful?
Thank you for voting!
The water filter needed to be replaced.
1 of 3 people
found this instruction helpful.
-
Alice from Wimberley, TX
- Really Easy
- Less than 15 mins
I screwed the old one out and replaced it with the new one. A no-brainer. The thing that was so amazing was that I ordered the filter on the intrnet and it arrived the very next day!!! I was very surprised and pleased with the very quick shipping!!!
Was this helpful?
Thank you for voting!
Water was leaking into the ice maker and into the ice bucket
0 of 1 people
found this instruction helpful.
-
Charlie from Huntsville, TX
- Really Easy
- 15 - 30 mins
-
Screw drivers, Wrench (Adjustable)
I removed the cover from the rear of the unit, with a screwdriver. Then with a adjustable wrench unscrewed the top nut of the water valve.I then removed the screw holding the valve to the wall of the fridge. Turned the valve upside down and removed the line going up to the ice maker. No tools needed here as it is a quick connect fitting.U
... Read more
se reverse order to install valve.I am 65 years old and if I can do this anyone can. Good luck from TX.
Read less
Was this helpful?
Thank you for voting!
refridge door stopper broken
1 of 4 people
found this instruction helpful.
-
Robert from Vacaville, CA
- Easy
- Less than 15 mins
-
Screw drivers
easy, a screw driver repaired in a mintue
Was this helpful?
Thank you for voting!
plastic tube leaking at connector
1 of 5 people
found this instruction helpful.
-
GREG from STILLWATER, NJ
- Really Easy
- 15 - 30 mins
-
Pliers, Wrench (Adjustable)
Uncoupled the old connector, replaced with new connector and attached supply line. Repair easy with right part, prior to ordering the right part I had tried a compression fitting and it still leaked. U-tube and others demonstrating repair assured me I was on the right path.
Was this helpful?
Thank you for voting!
Frig door not closing on its own accompanied by grinding sound
1 of 6 people
found this instruction helpful.
-
Joseph from Pennsville, NJ
- Really Easy
- 15 - 30 mins
-
Screw drivers, Socket set
IMPORTANT: REPAIR EASIER WITH ASSISTANT! Pull frig from kitchen cabinets & unplug. Remove food from freezer & frig doors. Have assistant hold freezer door closed against freezer. Remove hinge cap from top of freezer along with hardware using socket wrench. Carefully lift freezer door from hardware that joins the bottom of the freezer door
... Read more
to the top of the frig door. Rest freezer door upright off to the side. Have assistant open frig door & SUPPORT BOTTOM. Remove hardware from top of frig using crescent wrench & screwdriver. Carefully lift frig door off joint & lay on side to gain access to hardware on bottom. Remove hardware using a screwdriver & replace worn nylon bushing. Reverse disassembly steps. Remove frig & freezer door shelves & clean inside. Clean outside frig, especially the back vents. Clean the floor where frig lives & push back into place. Enjoy clean SELF-CLOSING, NON-GRINDING frig door!
Read less
Was this helpful?
Thank you for voting!
Frost in the freezer. Icemaker frozen.
1 of 8 people
found this instruction helpful.
-
Teresa from Miami, FL
- Really Easy
- More than 2 hours
I called LG and followed the instructions given over the phone. The instructions couldn't have been simpler. Disconnect the appliance for several hours and then connect again. I disconnected the appliance overnight, cleaned out the freezer, and reconnected it. Problem solved. Did not need to call a repairman and did not use the clips.
Was this helpful?
Thank you for voting!