795751 Kenmore - Instructions

Uncoupled the old connector, replaced with new connector and attached supply line. Repair easy with right part, prior to ordering the right part I had tried a compression fitting and it still leaked. U-tube and others demonstrating repair assured me I was on the right path.

Removed the old, replaced with new. . . That easy.

Remove push plate for water/ice maker switch, remove 2 screws and 2 wires for switch. Replace with new.

removed 1 screw and replaced

replace piece

Tape off the light button so door alarm does not go off. Take off the clear light shield and remove the light bulbs. Be careful, bulbs may still be HOT!! With Phillips head screw driver unscrew the light plate assy. Drop it down in a comfortable position. Disconnect the connector, unscrew the thermal sensor and remove light assy. Install ... Read more new light assy into light plate assy. There is no thermal senor in the new assy. Snap light plate assy back into place and install the two screws previously taken out. Install bulbs and clear cover. Remove tape from light door switches and you are done. Lights should go on and off when door buttons are pushed in and out.

Removed white plastic trim and installed new latch / cam shaft

I removed the old lamp cover and case. Discovered that the last repair person had not re installed it correctly so the case had melted from the bulbs. I Removed the screws that was supposed to hold it up, assembled the case and cover, inserted the screws and anchored them in where they belong. Problem solved!

Simple replacement part.

Simply used a flat head screwdriver to get the first few inches of the gasket out of its track and after that just pulled it by hand. New gasket slipped over the door, lined up the corner and pressed into in the track. Checked to see that it was snug all over and we were done. 5 minutes at the very most. Never would have noticed this. Too ... Read more k all the bins out of the freezer to give it a good cleaning and noticed the torn piece hanging. Our refrigerator runs much less often. Expect to see a difference in our electric bill!

I need the slide rails right and left for the center of the trays.

Changed door switch. Repair worked for a few days but re-occured. Possibly the other switch is bad .

I slid the new rails into the Cover for the vegetable bins, and installed inside the refrigerator. No tools needed for this part.

replaced melted light covers, replaced switches, and found another problem with power circuit board relay, on order now!!

The most time-consuming part is unloading the fridge so you can make the repair, and putting it all back in! Plus you clean everything (glass cover, etc) while it's out. The repair itself probably only took 25 minutes at most. You have to unscrew 4 screws to detach the center metal rails, then snap out the rails. Snapping them into the ne ... Read more w cover must be done carefully so as not to break off the tabs on the plastic part you're replacing. It requires a little hand strength (I have arthritis in my hands, so my husband did this part). Then put everything back together and restock the fridge.