My Orders
- Home
- 79032643310
- Instructions
79032643310 Kenmore Range - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Stove top spark module broken
7 of 8 people
found this instruction helpful.
-
Brian from DUDLEY, MA
- Easy
- More than 2 hours
-
Pliers, Screw drivers
Worst part was cleaning my disgusting stove, installation was easy, remember the positioning of the wires from defective module(take picture)
Was this helpful?
Thank you for voting!
Replace oven gas safety valve.
5 of 6 people
found this instruction helpful.
-
Hans from JERUSALEM, AR
- A Bit Difficult
- 1- 2 hours
-
Nutdriver, Pliers, Screw drivers, Wrench set
It went really well until test when the flame was reaching up into the oven itself, not good. Much research finally found an older repairman who informed me the nozzle that injects the gas into the oven burner had to be fully screwed down for LP Gas. The unit is pre-set for Natural Gas. Tightened it all the way down and everything work
... Read more
s just fine. We live rurally so use Liquid Propane Gas, not Natural Gas.
Read less
Was this helpful?
Thank you for voting!
Igniter failing to energize even though there was 120 volts being supplied.
1 person
found this instruction helpful.
-
Richard from MERCERVILLE, NJ
- Very Easy
- Less than 15 mins
-
Nutdriver
Slide Range away from wall, unplug Range, remove rear cover (4) screws, removed burner assembly (5) screws, unplugged Igniter connector, loosen Igniter bracket, remove Igniter (2) screws. Reverse process to install new Igniter. I also wore latex gloves to prevent touching graphite portion of Igniter. Tested Broiler for operation, slid Ran
... Read more
ge back into position. All good.
Read less
Was this helpful?
Thank you for voting!
Replace igniter
1 person
found this instruction helpful.
-
Edward from NORWOOD, PA
- Really Easy
- 15 - 30 mins
New part needed to be spliced to old connector with porcelain wire nuts then removed lower oven drawer to access the connection for igniter
Was this helpful?
Thank you for voting!