7800 (Type 2) Porter Cable Sander Polisher - Parts

This item is a genuine Porter Cable replacement part and has been sourced from the original manufacturer to be used with drywall sanders. The plastic hose is used to ling the hose adapter to the longer hose to collect dust to reduce the amount of drywall dust in the air. This item is available as an individual replacement part.

This is a genuine replacement part sourced from the original manufacturer for use with power tools. The metal screw is commonly used with several different types of power tools, and the application of the screw can vary based on the model of the power tool. This screw is available as an individual replacement part, please see model diagram for part location and usage.

This is a genuine OEM sourced replacement guide pin that connects to the pivot plate. It is designed for use with Porter Cable drywall sanders. It is made out of metal and it is sold individually. No tools are needed to replace it.

This is a Genuine OEM sourced replacement part designed for Porter Cable Drywall Sanders. This item is made out of Metal and it is Sold Individually. Over time the square ends of the Flex Shaft will become rounded and the unit will cease to operate correctly. You would need a Screwdriver and Pliers to replace this item.

This is a genuine OEM approved replacement part designed for use with Porter Cable drywall sanders. It extends below the surface of the abrasive pad to prevent the abrasive from "gouging" the work. It helps to contain the drywall dust until the vacuum cleaner pulls it away. It is made out of metal with plastic and it is sold individ...Read moreually. To complete this repair you would need a screwdriver. • Remove abrasive pad • Use phillips screwdriver to remove the six retaining screws • Lift the skirt out of housing • Position the new skirt to the housing and install the six retaining screws • Replace the abrasive pad

This is a casing for the drive shaft cable of a drywall sander, crafted from durable rubber and metal, and is an authentic OEM part. Over time, prolonged use, or in case of damage, replacing this casing is essential for your sander to maintain optimal functionality and to prevent dust accumulation around critical mechanical joints. To rep...Read morelace the casing, gather a screwdriver and wrench. Start by removing the pins securing the yoke to the pivot assembly of the sander. Next, pull the boot off the casing and proceed to remove the screws fastening the casing to the boom arm. Unfasten the other end of the casing from the sanding pad. Remove the casing from the shaft, and detach the boot and flange from the old casing to install them onto the new casing. Before installing the new casing, inspect the drive shaft for potential damage, as it might need replacement as well. Install the new casing onto the shaft and thread it onto the shroud. Screw the casing into the boom arm through its flange and reinstall the boot. Finally, resecure the yoke to the sanding pad by screwing in the pins on the other side.

This item is a genuine Porter Cable replacement part that is sourced from the original manufacturer and is intended to be used with drywall sanders. The plastic clamp is used to secure and connect the vacuum hose to the main hose. This item may not require tools to install and is priced as a single item.

The vacuum adapter goes next to the tube insulator and is made of plastic. This item is available as an individual replacement part. It is a genuine item that is supplied by the original equipment manufacturer for use with Porter Cable sanders. During replacement, it may require a screwdriver to help install this part correctly. This part may become broken and will need to be replaced.