76CB Maytag Dryer - Instructions

THERE WERE NO INSTRUCTIONS INCLUDED, COULDN'T FIGURE 0UT HOW TO INSTALL THE NEW ROLLERS ON THE NEW RACK FINALLY INSTALLED THE OLD ROLLERS ON THE NEW RACK AND THEY WERE MUCH EASIER TO INSTALL I DONT UNDERSTAND
WHY THE NEW ROLLERS WERE THE SAME AS THE OLD ROLLERS
EXCEPT FOR THE COST.

Snapped on the rollers, removed the center part from the old rack that sprays the water and snapped it on the new one. We then bent the back row down so it would acomodate my larger items. My old rack had that feature. You could either have the rack up or down. Now l
ooks beautiful and works perfectly.
Could have used some di ... Read more rections though.

YouTube was very helpful
New racks works better that way expected. Rearrange ment maximized loading

Kit didn't have the center conical piece. Easy to switch tho. I am impressed at the speed of which the part arrived.

installed a new rack

Since there were no printed instructions, we looked at the photo schematic.
Reassembly using the photo was easy by putting the old rack alongside the new one and adjusting the new rack spacing to match the old one.
We also had new wheels which snapped on.
We were delighted to repair and replace this good, older dishwasher r ... Read more ather than purchase a new one!

Swapped out the old upper dish rack with a new one. A video made the change simple.

The rack came with pictorial instructions which were fairly veg, however they were to the point. The wheels snapped into place easily, and the center water transfer tube twisted off the old one and twisted on the new one just fine. It is a very good idea to keep the old one out to look at as a guide. There were no instructions on how to r ... Read more emove the transfer tube, I was lucky to have already worked on these before. After that it fits and works just peachy.

I ordered a new rack, snapped the stuff together, and slid the old one out and the new one in. Fit beautifully. Piece of cake and much cheaper than a new dishwasher.

replaced worn parts

Assemblies snap on, no tools needed

New lint screen

Bought a house and inherited an ancient set of appliances. I figured that they dont make em like they use to so why get rid of them. Noticed the dryer tub wasnt spinning one day after running through three cycles. I took the back off and realized the belt that made the tub spin was broke. Went ahead and ordered both belts (old age catche ... Read more s us all) so i wouldnt have to order the other a few weeks later. Pulled the spring took the old belt off put on the new ones like ya would a bike chain. Used the pliers to put the spring back on and voila.

Purchased x4 new adjustable legs. Leaned the washer back and held in place with block of wood. Loosened the two older front legs with an adjustable wrench because they had a locking nut and replaced with new legs. Repeated process on back side of washer. Once all the new legs were installed leveled the machine adjusting the legs if nec ... Read more essary.

Remove dryer back,release spring tension to remove belts. Clean lint and pulleys. Replace belts,spring tension and back and LEVEL Dryer. NOTE: The back is part of the frame, make sure all screws tighten DO NOT omit any.