7505-87A Frigidaire Dryer - Instructions

Used a screwdriver to pop out broken piece. Used pliers to snap in new one.

Removed broken part. Pressed replacement into opening.

remove new latch from package, insert into dryer door frame push into place with thumb until it snaps into place. Done!

I watched a You Tube video first. I used a screwdriver to loosen the part that was attached to the dryer. I pulled it out of the dryer with pliers. I pushed the new part into place. The old latch worked fine so I did not replace it.

Literally pop it in the small opening. Super easy and works perfectly now!

Super simple pushed in the new receiver and boom all good and working

Followed video instructions, easy installation. Unfortunately it didn't fix the problem. Plan to take back off and check belt, etc before ordering another part.

The other door latch broke and fell out. I simply pushed the New Door Latch in the hole, and it snapped into place.

I replaced the latch on the body and on the door and it worked very well. I had to watch the video first. Thank you.

My son kept slamming the door wrong and eventually the catch broke and two and feel out. My husband is the handy man of the family, but has been so busy that I was just duck tapping the door close. Finally, I decided to see if I could look up the part. Found it on here, ordered it, and replaced it all myself! Proud mother right here! Very ... Read more easy. Works great.

It was super easy ! The part came and I had it done in less than ten minutes. No mechanical skills necessary !

Inserted clasp in frame of door

Popped in new catch and used needle nose pliers to squeeze old latch flat and remove from door. New one just popped into place.

Another parts website, instructed taking apart the dryer top and front and electrical connections etc. I thought I'd have to buy a new dryer!. Then I found your website, and I was laughing so hard, because your instructions were so simple and logical and took me under a minute to do the "repair". I used a plastic ... Read more ice scraper instead of a metal putty knife (so as not to scratch the finish) to pry out the broken part. Then using my fingers on one hand I pushed in the new part. I closed the door to make sure the dryer started. It did. The end. Also I was told it would be a couple days till I received the ordered part. It was here in less than 24 hrs. Thank you for your excellent help.

Once I received the product I placed it in the hole and it worked great.