74451 Toro - Parts

This part is sold individually and is made of plastic and metal. The single pole switch connects to the wiring harness. A set of pliers may be required to replace this part if it becomes broken. It is a genuine OEM sourced part which is specially designed for use with Toro and Lawn Boy for use in lawn tractors and riding mowers.

It is made of metal and is sold individually. The screw connects to the idler pulley. A socket set might be needed during the installation process. Over time this part may become stripped and will need to be replaced. This part is an OEM from Toro and Lawn Boy for use in snowthrowers, tillers, blower-vacuums, and lawn tractors.

This is an authentic replacement part sourced from the original manufacturer for use with Toro lawn tractors and riding mowers. The ignition switch goes next to the hour meter. If this part becomes broken it will need to be replaced and may require a screwdriver during the installation. This part is available individually and is made of plastic and metal.

This is an authentic Toro replacement part, sourced from the original manufacturer for use with riding lawnmowers. The oil filter is used to clean the engine\'s oil to limit contaminants that can build in the engine. This oil filter is sold as an individual replacement part.

This carburetor repair kit is a genuine OEM replacement designed for riding lawn mowers and lawn tractors equipped with select V-twin engines. It includes the essential internal components needed to service a worn or leaking carburetor, helping restore proper fuel metering, smooth idle, and reliable engine performance. Ideal for maintenan...Read morece and repair, this kit offers a cost-effective alternative to full carburetor replacement when gasket failure or internal wear causes starting issues, rough running, or reduced fuel efficiency.

This is a genuine Toro replacement part that has been sourced from the original manufacturer to be used with snowthrowers. The metal flat washer is used to disperse pressure put on a part assembly by a nut or bolt across a wider surface area. This item is used with several different models of snowthrowers. It is recommended to review your...Read more model\\\'s part diagram to confirm the washer\\\'s compatibility and usage. The flat washer is priced individually.

This is an authentic Toro replacement part manufactured for use with lawn tractors. The special insulator bushing is used to seal the fitting between the fuel valve and the fuel tank and to prevent damage to either part. This bushing is available as an individual replacement part, please see model diagram for associative parts.

This is a genuine Toro replacement part. The friction washer is designed by the manufacturer for use in lawn tractors. This part is used to help secure the idler arm and apply friction to its motion. You will require a wrench when replacing this item. This part is sold individually.

This is available as an individual replacement part. The o-ring seal goes next to the charge pump cover and is made of rubber. During replacement, it may require a socket set to help install this item correctly. It will need to be replaced if it becomes broken. It is a genuine OEM sourced part which is specially designed for use with Toro lawn tractors.

A deck wheel that drags, wobbles, or has a flat spot may no longer protect the turf correctly. The smooth roller touches the ground when the mower deck passes over a raised area, helping prevent the blade from cutting deep patches. Check deck level and tire pressure first because poor adjustment can also cause scalping. Match the replacem...Read moreent using the complete mower model and serial number, and compare the bore, width, bracket spacing, and required hardware. Shut off the engine, remove the key, set the parking brake, and disconnect the spark plug before service. Support the deck securely, tighten the fastener properly, and make sure the wheel turns freely.

This is a genuine Toro replacement part. The clip is commonly found in snowthrowers and lawn tractors. This part is made of metal, and is generally used to secure plate-like components in place. It may be used in various locations in the machine, depending on model. Please refer to the parts diagram to be sure of ordering the correct ...Read morepart. You may require a wrench or screwdriver when replacing this part. This item is sold individually.