72513 - Parts

Switch: Oil Pressure This oil pressure switch is designed for small gas engines to monitor lubrication levels and help protect the engine from damage caused by low oil pressure. Operating on a 12-volt system, it plays a k... Add to cart

Screw-hwhtf This is a genuine manufacturer-sourced component which is specially made for use with Toro snowthrowers. It is a standard hardware which may have multiple applications. Please make sure to refer to th... Add to cart

Locating Pin Add to cart

Bushing: Linkage Retaining Linkage Bushing Add to cart

Grommet: Rubber This replacement grommet is a high quality item designed for use on Kohler engines commonly installed on MTD lawn and garden equipment. It is a genuine item that is sourced from original equipment man... Add to cart

Engine Cover Knob An authentic replacement part which is supplied directly from the original equipment manufacturer for use with Kohler engines commonly installed on lawn and garden equipment. This special knob is used... Add to cart

Washer-belleville Add to cart

Nut: Flg M8x1.25 Designed to secure parts in place and spread the load, this Flange or Lock Nut is made of durable metal, is silver, is not part of a kit or assembly, and is sold individually. This part has been sourc... Add to cart

Connector This is an OEM part sourced directly from the manufacturer. The connector is commonly found in Kohler engines. This part is made of high-quality plastic, and is attached to the rectifier regulator t... Add to cart

Cover: Inner Air Cleaner This is an authentic item that is supplied directly from the original manufacturer for use with Kohler engines that are commonly installed on lawn and garden equipment. It is a high-quality replacemen... Add to cart

Nut-lock, Ni This lock nut is used to secure threaded fasteners, to prevent them from loosening and falling off during use. It is sourced from the original manufacturer for use in various lawn and outdoor equipmen... Add to cart

Washer-flat This item is priced individually. The flat washer goes next to the hub cap and is made of metal. During the installation process, a wrench might be needed to replace this part. It will need to be repl... Add to cart