7130 - Parts

A genuine item which is supplied directly from the original equipment manufacturer for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. It is an identical replacement for a damaged or missing governor link spring which was originally installed on a new unit, make sure to check the appropriate diag...Read morerams of your model for the correct location and application of this hardware. Keep in mind this high-quality component is made of durable metal and is sold individually.

This is a genuine OEM replacement part used with many lawn mower tractor engines. The crankcase gasket (.015 thick) is made of cardboard composite, and is fitted in the engine sump, providing protection from friction and leakage. A screwdriver and a socket set are required for the proper installation. The crankcase gasket is sold individually.

This item is a genuine OEM replacement part that is intended to be used with lawnmower engines from Briggs & Stratton and Toro. The metal needle is used as a valve that regulates the amount of fuel sent to the carburetor as the bowl fills and drains. This item is available as an individual replacement part.

This silver metal lock washer helps prevent the nut on the drive belt pulley shaft from backing off during operation, it has a 5/16-inch inner diameter and a 1/2-inch outer diameter. one washer is included, replace it if fatigue or damage allows the connected shafts to spin freely, verify fit using the equipment model or owner manual

This is a genuine Briggs and Stratton, Toro part for use with Engines, Lawn Tractors and Lawn Mowers. The tube breather vents air from the engine crankcase. The most common reason for replacing the tube breather is when it is misplaced or broken. This part is sold individually. The tools that you will need to replace the tube breather are a Philips-head screwdriver, 5/16th-inch socket or nut driver.

This is a genuine Broil-Mate, Broil King, Huntington, and Sterling part sourced directly from the manufacturer for use in gas grills. The grease shield goes next to the inner rear panel. A wrench and a screwdriver may be necessary during the installation of this item. It may become broken and will need to be replaced. This is made of metal and is available as an individual replacement part.

This part is the replacement push switch for your refrigerator. It is made of white plastic and is sold individually. The door switch turns the light on and off when you open the door, and it is also a safety mechanism that doesn’t allow the auger motor to come on and dispense ice when the door is open. To remove the switch, simply pry it...Read more out of position with a small flat head screwdriver, then disconnect the wires. Reconnect the wires to a new switch and snap it into place. Be sure to connect the wires to the switch in the correct order. This part is an authentic OEM part sourced directly from the manufacturer.