7130 - Parts

The Throttle Box Assembly, or the Throttle Assembly, is a kit that includes the housing, handle, and hardware. It is black and constructed of steel and plastic. It can be installed onto the right hand upper handle, using a screwdriver and pliers, and is rated as Medium difficulty to install. This kit contains the parts that control the ...Read moreamount of the air and fuel entering the engine. When the part breaks (likely due to fatigue) you will no longer be able to control the engine. If nothing happens when you move the handle, that means it has become disconnected. When the part is broken it must be replaced. Check your model number to ensure you are selecting the correct replacement part.

This water inlet valve is a genuine replacement part that controls the flow of water to your refrigerator’s ice maker and dispenser, helping ensure steady ice production and proper dispensing. It features a single-valve design with an attached wire harness and is used to replace a valve that may be leaking, failing to supply water, or cau...Read moresing slow ice and water output. Installing a new valve helps restore smooth, reliable operation. Be sure to disconnect power and the water line before replacing the part, and check your refrigerator’s model number to confirm the correct fit.

Hard starting or an engine that suddenly stops may point to a damaged magneto armature. This ignition coil turns magnetic energy from the spinning flywheel into the electrical pulse that fires the spark plug. First try a known-good spark plug and inspect the safety switches, grounding wire, terminals, and flywheel magnet. Confirm fit from...Read more the full engine identification numbers, since similar coils may mount differently. Work only with the engine off and cool. Disconnect the battery and spark plug lead before removing covers. During installation, use the air gap listed in the service manual and tighten the mounting screws evenly. Keep hands clear of the flywheel and use an insulated tester to check for spark.

The cam shaft is not included with the gasket retainer. It must be purchased separately.

This is a manufacturer approved starter pinion gear designed for use with lawn and garden equipment engines. This Starter pinion gear is attach to the starter clutch drive and engages the flywheel to start the engine. It is made out of Plastic and Aluminum and it is Sold Individually.

This freezer door gasket assembly is designed to form a tight, airtight seal around the door of select LG refrigerators and freezers. Made from flexible, high-quality rubber, it prevents warm air from entering and cold air from escaping, helping to maintain consistent internal temperatures and reduce energy consumption. A properly sealed ...Read moregasket supports food preservation and minimizes strain on the cooling system. Installation is straightforward—creases or folds in the gasket can be smoothed out by soaking it in warm water or using a low-heat hairdryer. Replacing a worn or damaged gasket restores the appliance’s efficiency and performance.