7080310 Snapper Lawn Mower - Parts

This authentic manufacturer-sourced component is specially designed for Murray, Snapper and Simplicity lawn mowers. It is an identical replacement for a missing or a damaged hex nut that was installed on a new unit. Check the diagrams for your specific model for the exact location and the correct application of this hardware. Keep in mind...Read more this high-quality product is made of durable metal and is sold as an individual item. A wrench will be needed to secure or remove it.

Screw 3/8-16x.75

This is an authentic replacement part manufactured for use with riding lawn mowers. For us in Snapper Riders with 12 and 12.5 HP Briggs & Stratton engines. The muffler is commonly used to reduce emissions and exhaust noise. This muffler is available as an individual replacement part, please see model diagram for associated parts.

This is an authentic Snapper replacement part. The spacer is commonly found in riding mowers. This part is made of metal, and is used to provide extra distance for the pivot spacers on the front frame. You will require a wrench when replacing this part. This item is sold individually.

Spacer differental case-axle shaft

This 3/4-16 hex jam nut is an original part from Snapper. The metal nut is compatible with many riding lawn mower engines, and is sold individually. This item assists with securing the spindle pulley. A wrench and pliers are needed for the installation.

This part is a genuine OEM replacement part for Snapper Rear Engine Riding mower. The part itself may differ in appearance, but it is a functional equivalent to prior parts for this series of mower. Although the parts look similar, be sure to check your Model Number according to your mower to ensure a proper fit.

This 0.25-inch-diameter washer with internal lock teeth is an authentic manufacturer replacement fastener used in outdoor power equipment. It has a flanged base, which provides even load distribution and protects the mounting surface from damage during installation and removal. The washer also has inward-facing teeth, providing additional...Read more grip to prevent the secured components from falling off the equipment. Over time, the washer will corrode, crack, or wear down its teeth, leading to equipment instability, noise, and vibrations. Inspect all the washers in your equipment and replace those that are no longer functional. Use a wrench or socket to loosen and remove the old washer, and then position the new one on the mounting surface. Tighten the washer until the flange rests flush against the surface. Each washer is sold individually.

The large boot attaches to the oil seal. This is an OEM from Snapper for use in lawn tractors. This item is available as an individual replacement part. It may require a wrench and a set of pliers during installation. It is made of rubber and will require replacing if it breaks.