7080098 Snapper Lawn Mower - Parts

The boot clamp attaches to the rear axle boot and the axle bearing and helps to hold them in place. It is a genuine Snapper and Murray replacement part for use in rear engine riders. This part is sold individually and is made of metal. If this part becomes broken it will need to be replaced and may require a set of pliers during the installation.

This is a genuine OEM sourced replacement part that is intended to be used with riding lawnmowers from Murray and Snapper. The metal hex nut is used with several different types of mowers and the application of the nut can vary based on the model of the mower. This item is sold as an individual replacement part.

The ball joint attaches to the king pin. This authentic item is supplied directly from the original equipment manufacturer for use with lawn mowers and lawn tractors made by Snapper and Simplicity. This part is made of metal and is sold individually. A wrench might be helpful during the installation of this part. It will need to be replaced if it breaks.

Cover steering shaft

This is an authentic replacement part manufactured for use with riding lawnmowers. The special positive cable has a red coating indicating it is a positive lead wire that connects the battery to the ignition switch. This special cable is available as an individual replacement part, please see model diagram for associative parts.

This part is an OEM Snapper and Simplicity part for use with Lawn Tractors and Lawn Mowers. The blade adapter attaches the mower blade to the spinning shaft. The most common reason for replacing the blade adapter is if it is worn or damaged. This part is sold individually. The tools that you will need to replace the blade adapter is a 5/8" socket, hammer and a torque wrench.

It is a genuine manufacturer-supplied part that is made for Murray and Snapper lawn mowers. This is the special spindle that the blade is attached to. It is a high-quality replacement for a damaged or a missing component that was installed on a new equipment. Make sure to check the diagrams for your model to ensure the correct repair proc...Read moreedure. Note, this spindle is made of durable steel and is sold as an individual item. A wrench set will be needed to replace this component.

It is a genuine manufacturer-sourced lockwasher that is specially designed for use with Murray and Snapper lawn and garden equipment. The purpose of this part is to provide a tight seal between connected components, unfortunately, over time the material may wear out and begin to fail eventually requiring a replacement. Keep in mind this h...Read moreigh-quality hardware is made of durable metal and is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this lockwasher.

This is a genuine replacement part manufactured for use with riding lawnmowers. This metal nut is used in a variety of applications to fasten different assemblies. Please see model diagram and part list for part location and usage. This nut is sold individually.

It is a genuine OEM sourced part which is specially designed for Murray, Snapper and Simplicity riding lawn mowers and garden tractors. The solenoid acts like an electromagnetic switch, it engages and routes the battery electrical supply to the engine starter when the ignition switch is rotated to the start position. Unfortunately, over t...Read moreime it may wear out or get damaged eventually requiring a replacement. Keep in mind this high-quality solenoid is sold individually. You will need a screwdriver and a wrench set to perform this repair. Check the diagrams of your model for the exact location and the correct installation of the new part.

Bolt 5/16-18x.625 g5