7008 - Parts

This item has been sourced from the original manufacturer and is intended to be used with snowthrowers from Toro. The metal woodruff key is used to link the motor drive shaft and the impeller pulley to allow the shaft to rotate the pulley. This woodruff key is priced as a single item.

This is an authentic replacement part manufactured for use with Toro snowthrowers. The special hex head screw is used with a variety of different snowthrower models and has multiple applications. This screw is available as an individual replacement part, please see model diagram for associative parts.

This is an original replacement part manufactured for use with outdoor power equipment. The oil seal is used with a variety of different models of equipment and is commonly used to form a seal where camshaft or driveshaft exit the crankcase. This oil seal is sold as an individual replacement part, please see model diagram for associative parts.

This is a genuine Briggs & Stratton, Toro, and Murray replacement part for use in engines, generators, lawn mowers, lawn tractors, and snowblowers. The stud is made out of metal. A wrench may be needed during the replacement of this part. It will need to be replaced if it breaks. This item is sold individually.

The screw is made of metal and attaches to the front panel. This is a genuine Toro and Lawn Boy part sourced directly from the manufacturer for use in snowblowers. Keep in mind that this item is sold individually. When replacing this part a flat head screwdriver might be required during the installation process. It might strip or break over time and will need replacing.

This is an authentic OEM sourced replacement piston ring set which is specially produced for Briggs and Stratton engines commonly installed on lawn and garden equipment. The purpose of these parts is to provide a tight seal between the piston and the cylinder walls. A worn or broken piston ring will allow combustion gases to escape the se...Read moreal and enter the crankcase, this would cause low compression and a loss of power. If compression is reduced significantly, the engine will not run at all. Please note this high-quality metal set is sold individually.

This is an authentic Briggs & Stratton replacement part manufactured for use with small engines. The timing key is used to fit into the slot on the crankshaft and into the key-way on the timing gear. This allows the timing gear to rotate with the crankshaft. The timing gear is available as an individual replacement part, please see model diagram for associative parts.

The switch assembly goes next to the rocker switch and is made of metal. This is sold as a kit that contains the switch, the nut, and the lockwasher. These are OEM parts from Toro and Lawn Boy for use in lawn tractors. If these items become broken they will need to be replaced and may require a wrench during the installation.

Kit-Carb Overhaul