7002 - Parts

Also known as the mounting clip. Holds the door switch in place on your appliance.

This is a genuine Husqvarna part for use with Husqvarna, Poulan and Jonsered Lawn Mowers. The height adjuster moves the lawn mower wheel up or down to adjust the lawn mower deck to the desired cutting height. The most common reason for replacing the height adjuster plate is if it is damaged. This part is sold individually. Here is a list ...Read moreof tools that are needed to install the left front wheel adjuster are a flat-head screwdriver, 9/16" nut driver, and a 3/8" nut driver.

It is a genuine OEM supplied item which is made for walk-behind lawn mowers. This is a high-quality replacement for a missing or a damaged pinion gear that helps to drive the mower's wheel. Unfortunately, over time due to friction, the teeth on the gear may wear out. If this happens it will no longer engage the wheel and the mower will no...Read moret move. To ensure the exact location and the correct installation of the new part, refer to the diagrams of your specific model. Note, one durable metal pinion is included. You will need a wrench set and pliers to remove the old pinion and secure the new one.

Made of high-quality metal, this hex flange locknut is designed for use with various lawn mowers and ride-on mower/tractor models and is sold individually. This locknut attaches to the end of the carriage bolt and is an important component to the axle assembly. This locknut has a 3/8-inch inner-diameter and is 16 threads-per-inch. To repl...Read moreace this locknut, you will need a wrench, and if there are multiple locknuts on your equipment, they may all need to be replaced.

Sold individually.

This is a genuine OEM sourced replacement part used on lawn mowers. This is the front wheel that helps to move your mower around. This wheel is made out plastic and it is sold individually. To replace this wheel you would need a wrench. • Remove the hub cap and the locknut • Replace the old wheel with the new one • Secure it with a nut and a hub cap

The E-Ring 7/16 is a 7/16-inch silver, metal part which can be attached to various locations on a variety of equipment to snap into grooves and secure parts into place. This part will require pliers to install. If broken, damaged or worn, there may be a problem with the part it is securing and the part should be replaced. Refer to your make, model and diagrams to check if this is the right part.

This part has been sourced from the original manufacturer and is intended to be used with walk-behind lawnmowers from Husqvarna, Poulan, Weed Eater, and Jonsered. The metal pawl is used to secure the pinion to the transmission axle to allow the two parts to rotate in unison. This drive pawl is priced as a single item, please note two may be needed.

This washer is not part of a kit or assembly. It is sold individually. With an O.D. of 1 inch, this OEM replacement part is made of dark grey metal and is used to provide a tight seal between the mower blade and the blade bolt/screw. This part should be replaced if you notice any visible wear, warping, or damage. You will need a wrench or socket set to complete this repair. Customers rate this repair as Easy.