6952 - Parts

Cup, fuel spitback w/nipple

Sourced directly from the manufacturer, this 6mm Flat Washer is made of durable dark grey metal, is not part of a kit or assembly, and is sold individually. This part should be replaced when it is damaged, worn, or can no longer spread the load under a bolt sufficiently. This Washer is found in various locations, depending on your model. Customers rate this repair as Easy.

This low-permeating fuel hose is a genuine OEM replacement designed for use on small engines. It carries fuel safely and efficiently from the tank to the carburetor while minimizing fuel vapor loss and resisting degradation from modern gasoline blends. Made from durable, fuel-resistant material, it’s intended to be cut to length during in...Read morestallation and is an ideal replacement when original fuel lines become brittle, cracked, or start leaking, helping restore safe and reliable engine operation.

This is an authentic OEM component from Kohler. The oil cooler o-ring is made for use with many small engines, and is sold individually. The plastic o-ring is fitted inside the oil cooler, providing a protective seal. An Allen wrench and pliers are often required for the proper installation.

This air cleaner cover is designed for small engines to protect the air filter from dirt, debris, and damage during operation. Built for a secure, precise fit, it helps maintain proper airflow and supports consistent engine performance. It’s a simple, direct replacement for restoring air filter protection when the original cover is cracked, loose, or missing.

It is the special linkage that connects to the throttle cable. This is a genuine item that is sourced from the original equipment manufacturer. It is designed for use with Kohler engines commonly installed on lawn and garden equipment. This is an identical replacement for a missing or a faulty component that was installed on a new unit. M...Read moreake sure to refer to the appropriate diagrams for your model for the exact location and application of this hardware. Keep in mind this high-quality throttle linkage is made of durable metal and is sold individually.

This is a Genuine OEM Sourced replacement part designed for Makita Impact Drivers. This part is made out of Metal and it is Sold Individually. This Washer helps to provide seal for the Sleeve. When replacing this part you would need a Screwdriver and Pliers.

Throttle Cable Clamp

Valve, exhaust oversized (.25)