69061 - Parts

It is a genuine OEM approved replacement part which is specially designed for use with Dynabrade equipment. This wrench allows a user to secure or remove the hardware, please make sure to check the user's manual for the correct application of this component. Keep in mind this high-quality item is made of durable metal and is sold individually.

The 6" hook-face sanding pad attaches to the balancer shaft. This item is available individually. This is an OEM part sourced directly from the manufacturer and used in sanders made by Dynabrade. It might require a screwdriver to replace this part. It is made of durable materials and will require replacing when it wears down.

This is an authentic Dynabrade replacement part manufactured for use with sanders. The Key is used connect the motor shaft and rotor assembly. This key fits into the slot on the motor shaft and aligns with the keyway in the arbor of the rotor assembly. They key is sold as an individual replacement part.

This is an authentic Dynabrade replacement part, sourced from the original manufacturer for use with pneumatic orbital sanders. The rubber lip seal shroud is commonly used to seal the connection between the sanding pad and the sander body. This lip seal shroud is available as an individual replacement part, please see model diagram for associative parts.

This steel part is manufactured by the original maker. It is used in various Dynabrade power tools including sanders and buffers. Ball bearings are used to reduce friction between metal parts. These parts need to be replaced regularly due to the effects of metal fatigue. This bearing is sold individually.

This is an authentic replacement part manufactured for use with Dynabrade pneumatic sanders. The sanding pad wears out from normal use and eventually needs to be replaced. This sanding pad is six inches in diameter, has a durable nylon backing, and is used to support adhesive sanding paper. The sanding pad is sold as an individual replacement part.

This is a replacement lock ring is specially made for use with Dynabrade power tools. It is designed to create a seal between two connected parts. Over time o-rings will become brittle allowing for air leaks. Because of this rings should be inspected periodically. If parts are showing signs of wear they should be replaced. This is a rubber o-ring and it is sold individually.

This is a manufacturer sourced replacement seal. It is specially produced for use with Dynabrade sanders. This is one of the seals for the tip valve/inlet bushing. Over time seals tend to shrink and crack allowing for air leaks. At that time it should be replaced to maintain top performance. It is made out of rubber material and it is sol...Read mored individually. Replacing this item you would need a wrench to replace this item.

This an authentic Dynabrade replacement part used in buffers and sanders. The spring is used to absorb shock from the valve when tool is in use. It goes between the air control ring and the tip valve. A wrench may be needed to properly install this part. This item is available as an individual replacement part.

This is a genuine item that is supplied by the original equipment manufacturer for use with Dynabrade orbital sanders. It is an identical replacement for a missing or a faulty muffler body that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this ...Read morecomponent. Keep in mind this high-quality muffler body is made of durable material and is sold individually. Note, the #57065 Cone Muffler is sold separately.

This is an authentic Dynabrade replacement part, sourced from the original manufacturer for use with random orbital sanders. The special balancer shaft is used to link the motor shaft balancer and the sanding pad. This balancer shaft is available as an individual replacement part, please see model diagram for associative parts.

It is a genuine item that is supplied by the original equipment manufacturer for use with Dynabrade sanders. The vacuum adapter goes next to the cone muffler. A set of pliers may be helpful when replacing this part. This will require replacing if it breaks. It is made of plastic and is sold individually.