6902 (Type 2) Porter Cable Router - Parts

Genuine OEM Replacement Part used on a variety of Power Equipment. This part is made out of Metal and is Sold Individually. Terminal Eyelet allows you to safely and easily secure a wire to the needed part of the tool using only a screw.

This brush is a genuine Porter-Cable replacement part, not generic. As pictured, this brush is ready to install and includes carbon brush, wire lead, and spring. This item is sold individually. Over time, brushes will wear down and eventually require replacement. This brush will fit the models listed in the 'Compatibility' section belo...Read morew. It is not guaranteed to fit any other power tool models. • Worn brushes are often the cause of a poorly running motor • Replacing brushes can fix an intermittent motor • New brushes can restore a motor’s electric braking Carbon motor brushes are one of the most commonly replaced power tool components. Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

A tool that cuts out when its cord is moved may have a damaged power cord. Before replacing it, inspect the plug, outlet, extension cord, switch, motor brushes, and connections inside the tool. Confirm fit with the complete tool model because the wire ends and strain relief may differ. Unplug the tool and wait for it to stop fully. Mark e...Read moreach wire before disconnecting it, and never bypass the ground wire. Follow the original cord path, tighten the clamp, close the housing, and have the tool tested for electrical safety before use.

This is a complete model #1001 Porter-Cable fixed router base. It is standard on all 690 series routers. It is a fixed base, and does not have a pistol grip handle or plunge functions. This base includes a grooved frame for height adjustment. It is often cheaper to replace the entire #1001 base than to purchase the parts separately...Read more. This is a complete base, and it ships assembled with the sub base, handles, and latch in place.

This Porter-Cable router sub base is an OEM replacement part. It is found on 690 series routers and allows a router to glide smoothly on the routing surface. This sub base comes complete with the plastic sub base and three countersunk screws for installation.

This is a genuine replacement part sourced from the original manufacturer for use with routers. The special straight edge guide is used to guide the router along the material being cut. This straight edge guide is available as an individual replacement part, please see model diagram for associative parts.

This Ball Bearing has metal shielding on both sides. This is a genuine Porter Cable replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This ...Read morereduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.