68639 Kohler Engine - Parts

This air cleaner/filter cover kit is supplied by the original manufacturer for use in lawn mowers. It includes one plastic cover, and the necessary mounting hardware - one knob, one seal and two metal brackets. The cover prevents moisture and debris from entering the air cleaner housing and damaging the air cleaner. The air cleaner cover ...Read morewill need to be replaced if it becomes cracked, damaged, or loose, to prevent contaminants from entering the engine. A faulty air cleaner cover will result in low power output, increased fuel consumption, engine stalling, and engine damage if left unaddressed. Remove the fasteners that secure the cleaner cover and pull it off the equipment. Clean the air filter housing and replace the air filter if necessary. It is recommended to inspect and replace the air filter every 3 to 6 months for optimal engine performance. Align the new cover with the mounting holes and secure it in place using the appropriate fasteners.

Hose clamp. This clamp replaces 25 237 14-S

Sourced directly from the manufacturer, this 6mm Flat Washer is made of durable dark grey metal, is not part of a kit or assembly, and is sold individually. This part should be replaced when it is damaged, worn, or can no longer spread the load under a bolt sufficiently. This Washer is found in various locations, depending on your model. Customers rate this repair as Easy.

This air cleaner cover is designed for small engines to protect the air filter from dirt, debris, and damage during operation. Built for a secure, precise fit, it helps maintain proper airflow and supports consistent engine performance. It’s a simple, direct replacement for restoring air filter protection when the original cover is cracked, loose, or missing.

This is a genuine item that is supplied by the original equipment manufacturer for use with Kohler engines commonly installed on lawn and garden equipment. The ignition module is designed to deliver pulses of high voltage to the spark plug, please make sure to refer to the appropriate diagrams of your model for the correct location and ap...Read moreplication of this part. Unfortunately, over time, components will wear out and may begin to fail eventually requiring a replacement. Keep in mind this high-quality item is made of durable materials and is sold individually.

This breather seal, also known as a breather vent or plug, is used within the engines of various power equipment models. It is used to regulate pressure, protect against dirt, debris and excess moisture, and extend the overall life of the engine it is in. Measuring 1-inch long and approximately 0.5-inches in outer-diameter, this breather seal is a part from the original equipment manufacturer.?

This is an original Kohler replacement part sourced directly from the manufacturer. The gasket-air cleaner is made of a cardboard composite, and is designed for use in over 150 small lawn and garden engines. This part is most often fitted between the elbow gasket and the air cleaner base. Please refer to engine manual for specific repair ...Read moreinstructions. This part is sold individually. A screwdriver may be necessary in making the proper removal and replacement.

Valve, exhaust oversized (.25)

This item is available as an individual replacement part. The screw attaches to the ignition module and is made of metal. If this item becomes stripped or broken it will need to be replaced and may require a wrench during the installation. This is an OEM part sourced directly from the manufacturer and used in engines made by Kohler and Toro.

This is sold as a kit that contains the breather, the gasket, and the plug. These are OEM parts from Kohler and Toro for use in engines. They may require a wrench during installation. Over time these parts may break and will need to be replaced. They go next to the clamp hose and the breather filter.