68523 Kohler Engine - Parts

This is an authentic replacement part manufactured for use with Kohler small engines. The valve springs are used to compress when the valve is open and extend to close the valve. The intake and exhaust valves use this spring, and it is sold individually.

This oil pressure switch is designed for small gas engines to monitor lubrication levels and help protect the engine from damage caused by low oil pressure. Operating on a 12-volt system, it plays a key role in triggering warnings or engine shutdown when pressure drops below safe levels. Built for dependable performance, it’s a practical replacement for maintaining proper engine protection and reliable operation.

Linkage Bushing

The governor cross shaft seal goes next to the plain washer. This part is made of plastic and is available individually. It is an authentic OEM sourced item which is specially produced for use with engines made by Kohler and Toro. A set of pliers may be required to replace this part if it becomes broken.

An authentic replacement part which is supplied directly from the original equipment manufacturer for use with Kohler engines commonly installed on lawn and garden equipment. This special knob is used to secure the air cleaner cover which is sold separately. It is a durable plastic component which is sold individually.

Designed to secure parts in place and spread the load, this Flange or Lock Nut is made of durable metal, is silver, is not part of a kit or assembly, and is sold individually. This part has been sourced directly from the original manufacturer. When the threads or ends become damaged or worn, it will no longer be able to hold pieces in p...Read morelace. At which point, it should be replaced. Refer to your owner's manual to determine if this is the correct part, as it is located in various locations on some machines. Customers rate this repair as Easy.

This genuine ignition coil assembly is an original replacement part supplied by the manufacturer for use with Craftsman lawn tractors. Designed to generate the high voltage required to ignite the engine’s spark plug, this component ensures reliable engine performance and efficient combustion. The assembly includes the ignition coil module...Read more, ignition wire, and spark plug boot, all pre-configured for straightforward installation. To replace the ignition coil, you will need a screwdriver to remove any engine shrouds or protective covers, and needle-nose pliers to disconnect the existing coil from the engine. For best results, refer to your equipment’s service manual and ensure the engine is cool before beginning installation.

This is an authentic item that is supplied directly from the original manufacturer for use with Kohler engines that are commonly installed on lawn and garden equipment. It is a high-quality replacement for a missing or faulty inner air cleaner cover, please make sure to check the appropriate diagrams of your model for the correct location...Read more and application of this part. This component is made of durable metal and is sold individually, keep in mind the hardware to secure it is sold separately.

This is an authentic OEM component from Kohler. The metal screw is made for use with many lawn and garden engines. Sold individually, this item often helps to secure the closure plate. A wrench is required for the removal and replacement. It is encouraged to purchase spares, as the screw can wear over time.