66512776K310 Whirlpool Dishwasher - Instructions

Removed all the old adjuster parts. Laid out new parts for each side. Would have helped if pictures had been better quality. Figured out how the parts would be installed before actually installing them. Almost messed up 2 plastic tabs by not understanding how 2 parts locked together with the tabs and shoved them together too far on the trial run but, was able to get them apart without breaking off the tabs. The new parts are a stronger design than the original. The tracks work like a dream. I rated it a "Bit Difficult" because in the pictures I could not see enough detail, otherwise I would rate it easy.

Remove old rack adjusters. No removal instructions. Do one at a time. First requires some trial & error until removed. Install new replacement. Instructions not clear because pictures are dark & fuzzy. Again, install one with some trial & error. Second remove & replace becomes very easy.

I read through the instructions which actually took longer than actually doing the repair because some of the pictures were a little dark and it wasn't clear exactly which direction the parts were facing. The repair went exactly as the directions said.

Watched on line video, helped tremendously. The video gave clear concise instructions.

Unsnapped old adjusters, new ones went in easy after reading instructions.

I disassembled the left side, and installed the new assembly. However, being older and my eyesight not the best, and had assembled it slightly out of position. After adding more light, a magnifying glass. and a much closer look, I found my mistake. I reassembled the unit. The right side only took about ten minutes. I would recommend a larger more visible picture of the unit. I noticed that the units did not roll as easily as the old ones. One must give a slight push to engage the tray into the back of the dishwasher. Had the picture been better, it would have taken only 20 or 30 minutes to assemble.

I had left one adjuster on but the new ones were different. I started great but when doing the top part I didn't line up the wire rack with the holes in the upper adjuster plate and found out it was wrong so I had to use the pliers to unsnap the metal piece where they lock in. Once I got the first one complete it only took about 5 minutes to do the other side. The pictures included with the installation sheet were very dark. A you tube video would have been a great asset. It would have made it very simple and easy. In truth, the second side should only take a minute or two because I was only using one hand. My other arm was in a cast because I broke it. Anyone could do this.

I went on line as instructed by one of your representatives and found clear instructions how to remove old part and put on new one. It was an excellent presentation. It can be found at w10712394 instructions

I looked up a you tube video of replacement for model and part. the video gave consise, clear and easy to follow directions. Using the video it took about 15-20 minutes to easily do the job.(I had difficulty seeing photos and reading printed directions that accompanied the part.)

Trial and error

I watched this Youtube film: And it was really easy!

Instruction sheet is good but should stress that the thumb pads must face the front side of the dishwasher.

Removed old adjuster rack from both sides using a screw driver. Followed directions provided with rack adjuster kit and installed new adjuster on both sides.

This was my 4th time replacing these parts. Old parts where all plastic and I was lucky to get 6 months before they all disintegrated from the hot water washing. New parts are steel and replacing the old plastic parts was a piece of cake. Looks and even feels much stronger! Excellent youtube video

Ordered the parts and installed them according to the enclosed instructions & photos that came with the repair parts.