650C - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
broken drive axle chain
3 of 4 people
found this instruction helpful.
-
richard from MECHANICSVLLE, VA
- Really Easy
- 30 - 60 mins
removed engine, sheet metal, handle bars, and tines. Seperated transmission case and replaced broken chain. This is not difficult it's just time consuming. A tiller repair shop would charge about $400 to do this job. It cost me $40 for a chain and gasket, Both fit perfectly, great service. Thanks
Other Parts Used:
Was this helpful?
Thank you for voting!
Spring on clutch cable broke
2 of 3 people
found this instruction helpful.
-
David from SKANDIA, MI
- Easy
- 30 - 60 mins
-
Nutdriver, Screw drivers, Wrench set
Remove L. wheel.
Remove guard shield.
Remove old cable.
Install new cable.
Adjust throw on cable.
Put all parts back and test
Remove guard shield.
Remove old cable.
Install new cable.
Adjust throw on cable.
Put all parts back and test
Was this helpful?
Thank you for voting!
cable had broken
5 of 12 people
found this instruction helpful.
-
george from SYLVESTER, GA
- Really Easy
- 30 - 60 mins
-
Pliers, Wrench set
replaced clutch cable
Was this helpful?
Thank you for voting!
replaced old belt
5 of 16 people
found this instruction helpful.
-
David from WINSTON SALEM, NC
- Easy
- 30 - 60 mins
-
Socket set, Wrench set
took cover off and replace belt
Was this helpful?
Thank you for voting!
Gas tank leaking, pull starter rivets worn, rope and rope bushing worn
3 of 10 people
found this instruction helpful.
-
Dennis from EUFAULA, OK
- Easy
- 30 - 60 mins
-
Nutdriver, Screw drivers, Socket set, Wrench set
The gas tank was a simple job, close the fuel shut off, remove fuel hose then back out 2 bolts on the mounting bracket. Reverse procedure to mount.
To replace the pull starter/recoil assy. Remove low oil warning light, and air filter housing then remove the 4 bolts holding the front cover. Once the front cover is free remove kill sw ... Read more itch wire
Drill out the rivets holding the recoil housing w/ 3/16 bit. Screws w/ nuts are included to use in place of rivets, I used red Locktite on the screws which hold the started recoil to the front cover. Make sure the pull rope is correctly oriented in the 11:00 position. Replace front cover, four bolts. Air filter housing, kill switch wire and low oil warning light
To replace the pull starter/recoil assy. Remove low oil warning light, and air filter housing then remove the 4 bolts holding the front cover. Once the front cover is free remove kill sw ... Read more itch wire
Drill out the rivets holding the recoil housing w/ 3/16 bit. Screws w/ nuts are included to use in place of rivets, I used red Locktite on the screws which hold the started recoil to the front cover. Make sure the pull rope is correctly oriented in the 11:00 position. Replace front cover, four bolts. Air filter housing, kill switch wire and low oil warning light
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!