642F MTD Snow Blower - Parts

This is a genuine OEM sourced part which is specially designed for use with lawn and garden equipment. It is an identical replacement for a missing or a faulty bolt that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind t...Read morehis high-quality hex bolt is made of durable metal and is sold individually. Note, you will need a wrench to secure or remove it.

This is an authentic part that has been sourced from the original equipment manufacturer for be used with lawn and garden equipment. The part helps to support and guide the cable. It is an identical replacement for a missing or a damaged component that was installed on a new unit. Keep in mind this high-quality cable guide is sold as an individual item.

This Bell-Wash Flat Washer is an OEM part that measures .40 inches I.D. x 88 inches O.D. This washer is a silver, metal, washer sold individually. This part is rated as Easy to install by customers. If missing or damaged (likely due to fatigue) it should be replaced. Refer to your owners manual to ensure this is the correct part for you.

This is a genuine OEM sourced replacement part that is intended to be used with snow throwers from MTD, Ryobi, Yard Machines, Bolens, Yard-Man, Troy-Bilt, and Tecumseh. The metal flange bearing is used to support the worm shaft within the gear case. The flange bearing is sold as an individual replacement part.

It is an authentic manufacturer-sourced component which is specially designed for use with snowblowers. The part is utilized to cover and protect the gears inside the transmission. If the original item is damaged or is missing, this will provide an identical replacement. This LH reducer housing assembly is made of high-quality metal and i...Read mores sold as an individual item. Check the diagrams for your model to ensure the correct replacement procedure. A wrench set might be needed to perform this repair.

This authentic manufacturer-supplied part is designed for Craftsman snowblowers. Flange bushings are used to provide support for components while allowing them to rotate with minimum friction. It is made of high-quality material and is sold individually. Make sure to check the diagrams for your model to ensure the correct replacement proc...Read moreedure. You may need a screwdriver and a wrench set to take apart and reassemble the equipment when performing this repair.

This is a genuine MTD replacement part. The spring roll pin is designed by the manufacturer for use in chippers and snowblowers. This part is made of metal, and may be found in various locations in the machine, depending on model. Please refer to the parts diagram to be sure of ordering the correct part. You may require pliers or a punch set when replacing this item. This part is sold individually.

It is a genuine item that is supplied directly from the original manufacturer for use with snowthrowers. The friction disc is an important component of the drive mechanism that helps to propel the equipment forward. Unfortunately, over time it may wear out or get damaged eventually requiring a replacement. If the friction disc is worn or ...Read moredamaged, the snowblower will move slowly, erratically or not move at all. Please make sure to check the diagrams of your model for the correct location and application of this part. Keep in mind this high-quality assembly is made of durable metal and is sold individually.

This is a genuine replacement part sourced directly from the manufacturer. The shave plate is commonly found on snowblowers from MTD and Yard Man. This part is made of metal, and is used at the base of the spiral housing to scoop snow up from the ground into the blower. You will require a wrench when replacing this part. This item is sold individually.