6152 - Parts

This heating element assembly is a genuine OEM replacement designed to restore proper heat output in select LG and Kenmore electric dryers. Operating at 240 volts and 5400 watts, the assembly includes the metal heating coil, housing, wiring, a high-limit thermostat, and a thermal fuse to ensure safe and efficient performance. It is the pr...Read moreimary component responsible for generating the heat required to dry clothes. A failing heating element may result in no heat, extended drying times, or insufficient temperature levels. The included 3-terminal thermostat supports compatibility with specific models. Replacing this part can improve energy efficiency and restore original drying performance. Always verify model compatibility before installation and disconnect power for safety.

This belt helps rotate from the drive motor to the drum.

This plastic adjustable dryer leg is used to support the weight and adjust the height of your dryer to keep it level. To install the leg, tip the dryer back and screw it into the bottom of your dryer unit. Please note that this dryer leg is sold individually.

This light bulb provides interior illumination, making it easier to see contents or monitor operation. Designed to withstand heat and vibration, it restores visibility when the original bulb burns out or dims over time.

This motor works with the belt to drive your dryer's drum.

This dryer side vent kit lets you vent the exhaust to the side or bottom of your dryer instead of the default rear position. Included in the kit are 2 straight aluminum foil outlet ducts, each 4 inches wide, along with 1 duct elbow, 1 cover plate, 1 screw, and an instruction sheet. This is helpful for flexible installation in areas where ...Read morerear venting is not possible or practical. All parts are genuine replacements from their original manufacturer.

This assembly is the tub, felt seal and 3 baffles in the tub.

This is a lint filter guide cover for models of LG dryers. This guide cover is installed over the lint filter housing within your dryer and ensures that the lint filter is secured during the drying cycle and can be removed afterward. This cover guide measures approximately 15 inches long and 3.75 inches wide and is made of durable plastic...Read more that features two securing holes on either side of it that fasten it within your dryer. To replace this OEM guide cover, you will need a Philips-head screwdriver to remove and install it. This guide cover is sold individually and does not include the necessary securing screws.

This moisture sensor wire harness connects the sensor bars to the dryer’s control board, enabling accurate detection of fabric dampness to prevent over-drying and improve energy efficiency. Designed for a precise fit, this single harness ensures proper communication between the sensors and the control system, restoring optimal drying perf...Read moreormance when the original part fails. Common signs of failure include clothes remaining too wet or becoming over-dried. For safety, disconnect power before installation and follow manufacturer guidelines.