6149 Milwaukee - Parts

This replacement gearcase assembly is a high quality item that is specially manufactured for Milwaukee angle grinders. It is an authentic item that is sourced from original equipment manufacturer and it is sold individually. It is the metal assembly that houses and protects the gears that help to drive the unit. Please note to replace this part you will need a screwdriver set.

Included in part number 14-30-0302

This part is made of metal and is sold individually. The ball bearing fits between the commutator insulator and the baffle. It may require a screwdriver during installation. It might become worn down over time and will need to be replaced. This is an original Milwaukee part for use in grinders and sanders.

This part is provided by the original manufacturer for Milwaukee power tools. The metal bearing is used to prevent friction between moving parts, and usually goes inside a gear. The item includes one needle bearing, and please be aware any associated parts are sold separately. Please refer to your models parts diagram for any additional parts.

This is an Original replacement part used on certain Milwaukee Angle Grinders. This part is made out of Metal and it is Sold Individually. The purpose of this Flange is to hold the Grinding Wheel to the Spindle Shaft. Flange designed to accommodate 7/8 In. hub depressed center wheel.

This is a Genuine OEM replacement Flange Nut used on Milwaukee Grinders. This part secures the Grinding Disk to the unit. A Spanner Wrench (Sold Separately) is used to tighten and loosen this part. It is made out of Metal and it is Sold Individually.

This is a lock lever for various models of sanders and grinders. This lever is a safety feature designed to stop and prevent the sander disc from spinning when not in use. Not only is this lever a safety feature, it also allows users to change discs without worrying about the disc spinning unintentionally. If your grinder or sander is mis...Read moresing its lock lever, it is imperative that you replace it immediately to avoid personal injury. Replacing this lever requires no tools and can be done by simply pulling the old lever out and installing the new one in its place.

This replacement side-handle assembly is specially designed for Milwaukee angle grinders. It is an authentic OEM sourced item, not an aftermarket imitation. This side handle is secured to the grinder to provide a comfortable grip for the tool. It consists of a plastic handle and the threaded metal shaft. Replacing this item is very easy and it does not require any tools.

This item is an authentic Milwaukee replacement part that has been OEM sourced to be used with angle grinders. The guard attaches to the bottom of the gear case to cover the grinding disc to protect the operator. This item is available as an individual replacement part.