613SPECIAL Simplicity Lawn Mower - Parts

This is a genuine replacement part manufactured for use with outdoor power equipment. The special nut is used with a variety of types of equipment and the application of the nut varies depending on the model of equipment. This nut is available as an individual replacement part, please see model diagram for the nuts location and usage.

The idler pulley attaches to the belt guard and is made of metal. This item is priced individually. It is a genuine replacement part sourced from the original manufacturer for use with lawn mowers and lawn tractors made by Simplicity and Snapper. A wrench might be helpful during the installation of this item. Over time this part may break and will need to be replaced.

This is an authentic replacement part manufactured for use with Briggs & Stratton small engines. The idle mixture kit is used to adjust the amount of fuel that is sent to the engine's intake while the engine is idling. This idle mixture kit is available as an individual replacement part.

This OEM valve stem regulates air flow in and out of tires, allowing for inflation and deflation. It features an 11.5mm outer diameter, 31.75mm total length, and 22.35mm effective length. It is a metal valve with a threaded plastic cap, housed in plastic. To determine if a valve stem is broken, you can check for signs of damage or leakage...Read more. Signs of a broken valve stem include cracks, bends, or air leakage, which should be replaced to prevent tire deflation and operational issues. To remove the valve stem, fully deflate the tire first. Then, disconnect the tire from the rim to access the inner part of the rim. You may need to unthread any securing nuts if present. Use a pair of pliers to grip at the base of the valve stem and then unscrew it from the rim hole.

It is a genuine manufacturer-sourced replacement part which is supplied for use with Snapper lawn and garden equipment. This is a special hardware which has multiple applications depending on the model of your unit, please make sure to check appropriate diagrams for the correct location and use of this part. It is a high-quality component...Read more which is made of durable metal and it is sold individually, note you will need a wrench or a Torx screwdriver to install or remove it.

The alternator connector wire is made out of plastic and metal. It is available as an individual replacement part. This genuine item is supplied by the original equipment manufacturer for use with engines, generators, lawn mowers, lawn tractors, and snowblowers made by Briggs & Stratton, Toro, Lawn Boy, and Murray. A screwdriver, a socket...Read more set, a wrench set, and a nutdriver might all be helpful during the installation of this part. It may become broken and will need to be replaced.

Set screw

This is a genuine replacement part sourced from the original manufacturer for use with lawnmowers. The metal washer is commonly used to disperse pressure put on a part assembly by a nut or bolt across a wider surface area. This washer is used with several different models of lawnmowers, and the application of the washer can vary based on the model of mower.

This is an authentic replacement part that has been sourced from the original manufacturer to be used with small engines from Briggs & Stratton and Toro. The metal pin is used to connect the connecting rod to the piston assembly. This item is available as an individual replacement part, please see illustrated diagram for associative parts.

This is an authentic replacement part, sourced from the original manufacturer for use with small engines from Briggs & Stratton and Toro. The gasket is used to provide spacing and to seal the connection between the engine sump and the crankcase. This item is available as an individual replacement part.

The standard ring set is part of the standard piston assembly. These are authentic Briggs & Stratton and Toro replacement parts that are sourced from the original manufacturer for use with engines, generators, and lawn mowers. They are made out of metal. When replacing these parts a set of pliers might be required during the installation process. These items may become broken or bent and will need to be replaced.