6101 (SER 878C) Milwaukee Bandfile - Parts

Genuine Milwaukee replacement part Includes 1 carbon brush with wire lead attached, Sold individually • Worn brushes are often the cause of a poorly running motor • Replacing brushes can fix an intermittent motor • New brushes can restore a motor's electric braking Carbon motor brushes are one of the most commonly replaced ...Read more power tool components. • Because carbon brushes are wear items, meaning that through friction and use they will gradually wear away, they will eventually require replacement. • Worn brushes are common causes of intermittent motor function, reduced electric braking, and reduced motor power. • A worn out brush will often be worn down near the wire lead and may be cracked, pitted, or burned. • When replacing carbon brushes, be sure to also inspect your armature for burns, cracks, or other damage which indicates a larger motor problem.

This is a genuine OEM sourced replacement part which is specially designed for use with Milwaukee power tools. It is a standard hardware which has multiple uses based on the model of your tool, please make sure to check the appropriate diagrams for the correct location and application of this component. This screw is made of high-quality ...Read moremetal and is sold individually, you will need a flat-head or a Torx screwdriver to secure or remove it.

Inner diameter 3/8" Outer Diameter 1"

Included in part number 14-30-0302

This part is provided by the original manufacturer for Milwaukee power tools. The metal bearing is used to prevent friction between moving parts, and usually goes inside a gear. The item includes one needle bearing, and please be aware any associated parts are sold separately. Please refer to your models parts diagram for any additional parts.

This cord is an authentic Milwaukee replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. rnPower Cord Specifications: rn • 2 Prongs rn • 2 Wires rn • 18 Gauge rn • 8 Feet Long

This item is available as an individual replacement part. The dust cover fits between the support rod and the spring. When replacing this part a screwdriver might be required during the installation process. It is made of plastic and will need to be replaced if it breaks. This authentic item is supplied directly from the original equipment manufacturer for use with Milwaukee bandfiles.

This part is an OEM from Milwaukee. The bandfile head assembly kit is composed of metal and plastic, and is sold individually. This is a complete assembly for a bandfile head used on several angle grinders. A screwdriver and pliers are often helpful with the removal and replacement. Please refer to manual for specific repair instructions.

It is a genuine OEM sourced item that is designed for use with Milwaukee power tools. This special bearing allows spindle shaft to rotate freely with minimal friction, over time the rollers of the bearing may begin to wear out and fail eventually requiring replacement. It is a high-quality component which is made of durable steel and it is sold individually.

Included in part number 14-30-0302