608L Simplicity Lawn Mower - Parts

The OEM E-Ring is a silver metal part used to secure the wheel on the shaft. If broken, the wheel may fall off, and the part must be replaced. It is rated as "Easy" to install and requires pliers and a screw driver.

BOLT, 5/16-18 x 3/4" Short Neck Carriage, GR 5

This metal washer is a genuine OEM part that is commonly used on various lawn equipment and is typically used to secure and seal connected components. This washer is high-quality and is sold individually, so consult with the relevant diagrams for your model to correctly determine where this washer would be for your equipment, and whether you need one, or more.

This part is made of metal and is available as an individual replacement. The blade adapter fits between the washer shim and the retaining ring. An allen wrench may be required to replace this item if it becomes broken. This item is an original part from Snapper, Murray, and Simplicity for use in mower tractors.

This high quality air cleaner cartridge is an authentic OEM sourced item designed for use with Briggs and Stratton engines commonly utilized on Toro lawn and garden equipment. It is used to remove the dust and other contaminants the from the air going into the carburetor. This pleated paper cartridge is sold individually. Please note, the...Read more foam pre-cleaner is not included, it is sold separately. Replacing this filter-air cleaner cartridge is a very simple task that does not require any tools. • Remove the cover • Take out the old cartridge • Secure the new cartridge • Secure the cover back

This hex locknut has a special locking feature to prevent it from loosening due to vibrations or movement. It has a 1/4 inch diameter and a 20 threads-per-inch pitch. You will find it securing various parts of your lawn equipment, such as blade assemblies, engine mounts, or handles. A broken locknut cannot fasten components together tight...Read morely. Replace any damaged locknuts to keep your machine securely assembled and functioning properly. Loosen a locknut from your machine by turning it with a wrench or a socket. This durable metal locknut is an OEM hardware. It is sold individually, so read your user manual to determine how many you will need. Consider getting extras if you are replacing one, as these locknuts tend to wear out together.

This is a genuine OEM authorized replacement part which is specially designed for use with Murray, Simplicity and Snapper lawn and garden equipment. It helps to secure components together, please make sure to check the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality ring is made of durable metal and is sold individually.

This is a genuine replacement part sourced from the original manufacturer for use with outdoor power equipment. The special screw is used with different types of equipment and the application of the screw can vary depending on the model of equipment. This screw is available as an individual replacement part, please see model diagram for part location and usage.

This is a genuine Simplicity replacement part used in compatible mowers and tractors. The relief bearing attaches to the wheel and is made of metal. If this part wears down it will need to be replaced and may require a set of pliers and a hammer during the installation. It is available as an individual replacement even though two may be needed.

Key-ignition indak

This is an authentic manufacturer approved replacement carburetor float designed for use with Briggs and Stratton engines. This float controls fuel flow into the carburetor bowl by adjusting the needle valve. It is made out of white plastic and it is sold individually. Please note the metal pin that secure the float is sold separately. To complete this repair you would need a wrench and pliers.

This is a genuine replacement part sourced from the original manufacturer for use with snowthrowers and lawnmowers. The special capscrew is used with several different models of equipment, and the application of the capscrew can vary based on the model of snowthrower or lawnmower. This capscrew is available as an individual replacement part, please see model diagram for associative parts.