Home
602W
Instructions

602W - Instructions

All Instructions for the 602W

Stripped leveler screw making impossible to level my washer

24 of 31 people found this instruction helpful.

Rebecca from Wylie, TX
Easy
15 - 30 mins
Wrench set

Put blocks under the washer where the leveling leg was needed and screwed the part into the washer. Then it was just a matter of moving the washer into place and leveling. Pretty easy.

Other Parts Used:

Adjustable Leveling Leg

Rubber Foot Pad

Was this helpful?

honeycomb filter in vent fell out..

8 of 10 people found this instruction helpful.

Larry from Brentwood, TN
Very Difficult
1- 2 hours

The honeycomb filter in the vent was missing so I bought the entire vent cap.. Thought it attach with 2 screws from inside the oven.. BUT -- when you loosen the screws, it wouldn't drop.. Looked at the new part and saw that it attaches to the vent outside the oven as well.. So to replace this puppy, you have to pull the cabinet apart.. ... Read more r />
Left it for another day.. Hopefully no grease fires..
Read less

Was this helpful?

Thank you for voting!

Threads on old legs had been damaged in moving to new location.

4 of 4 people found this instruction helpful.

Wayne from SEDONA, AZ

Really Easy

30 - 60 mins

Wrench (Adjustable)

Removed the damaged legs, replaced with parts from this site and leveled the washer .

Was this helpful?

Thank you for voting!

worn roller wheel and bearing

0 of 1 people found this instruction helpful.

David from Chadds Ford, PA

Easy

30 - 60 mins

Nutdriver, Screw drivers, Socket set, Wrench set

replaced worn parts

Was this helpful?

Thank you for voting!

Deteriorated and clogged strainer; slow water fill.

2 of 7 people found this instruction helpful.

Richard from Jupiter, FL

Easy

Less than 15 mins

Pliers

Loosened the hose coupling, removed the old washer and strainer; cleaned the opening; flushed the opening; installed new strainer and washer; reattached hose and "Bob's your uncle"! No problem.

Was this helpful?

Thank you for voting!

Leg was mssing after move into new home.

Matthew from The Woodlands, TX

Easy

Less than 15 mins

Wrench (Adjustable)

Purchased x4 new adjustable legs. Leaned the washer back and held in place with block of wood. Loosened the two older front legs with an adjustable wrench because they had a locking nut and replaced with new legs. Repeated process on back side of washer. Once all the new legs were installed leveled the machine adjusting the legs if nec ... Read more essary.
Read less

Was this helpful?

Thank you for voting!

All Instructions for the 602W

1 - 7 of 7
Prev
Next