6021- Milwaukee - Parts

Genuine Milwaukee replacement part. Includes one Pad. This Pad is used to hold 5 inch Hook and Loop sandpaper with 8 vacuum holes. Over the past few years the popularity of Hook and Loop paper has grown because of the ease of changing sandpaper when needed. Over that of the PSA (Pressure Sensitive Sandpaper) Applying too much pressure...Read more on the sander may cause premature wear on the Hook and Loop pad. When a pad needs to be replaced, simply remove the four screws that hold the pad to the sander, then replace it with a new pad. • Standard hook and loop pad for use with 5" discs. • It has 8 dust collection holes which works in conjunction with the dust bag to keep you work surface free of debris.

This is a genuine Milwaukee replacement part, It is sold individually. This part controls the random orbit functions of of the Milwaukee sander it is used on. If this part breaks or gets worn, the sander will operate poorly and the pad will rotate at a high rate of speed.

This is an authentic OEM part which is designed for use with Milwaukee tools. It is a special hardware which helps to secure components. This is an identical replacement for a damaged or a faulty part that was installed on a new unit. Check the appropriate diagrams for your model for the exact location and the correct installation of this...Read more retaining ring. You will need snap-ring pliers to remove the old part and secure the new one. One durable metal retaining ring is included.

This is genuine OEM supplied replacement dust bag. It is specially produced for Milwaukee palm sanders. The purpose of this bag is to collect the dust and debris when using the sander. This fabric dust bag is sold individually. Please note, the plastic locking ring and the compression spring are all sold separately. Replacing this dust bag is a simple task that does not require any tools.

This plastic on-off switch is sourced directly from the original equipment manufacturer. It is used in Milwaukee random orbit/sheet palm sanders. This plastic part has metal terminals and is protected by the rubbery switch boot. Please note that the switch boot is sold separately. A torx screwdriver is needed for this repair. • Make ...Read moresure the tool is unplugged • Remove the cover/housing • Remove old switch and disconnect wires • Secure new switch • Attach wires • Replace cover and test the tool

This item has been OEM sourced to ensure a high-level of quality. The durable plastic locking ring is intended to be used with random orbital sanders from Milwaukee. The ring is used to fasten the dust bag to the dust chute assembly. This part is priced as a single item.

This compression spring is supplied directly from the original equipment manufacturer. Constructed of metal, this Milwaukee part is compatible with several palm sander devices. The spring is fitted onto the locking ring dust bag, holding it open. This part is sold individually. A screwdriver is helpful in making the repair.

This is an authentic manufacturer-sourced replacement component that is specially designed for use with Milwaukee sanders. It helps to provide an air-tight seal between connected parts, please make sure to refer to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality item is made of durable rubber and is sold individually.