6016 - Parts

This is an OEM part sourced directly from the manufacturer. The nylock nut is commonly found in snow throwers and lawn tractors from Murray and Snapper. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different nuts used in the machine. Refer to the p...Read morearts diagram to be sure of ordering the correct part. You will require a wrench when replacing this item. The nylock nut is available as an individual replacement part.

An authentic manufacturer sourced part which is supplied for use with Briggs and Stratton, Murray, and Snapper lawn and garden equipment. This replacement nut has a few different applications, please make sure to check the appropriate parts lists and diagrams of your model for the exact location of this hardware. Note, this durable metal nut is sold individually. You will need a wrench to secure or remove it.

Washer-0.312(0.33idx1

Lockwasher split 3/8

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This is a genuine OEM replacement part, it is sold individually. This part is used to keep the brush tight against the armature so the tool will work properly. Over time when the brushes wear down and heat is created, the spring may lose its tension and will have to be replaced.

The bolt attaches to the pulley bearing. It is made of metal and is available individually. This part is an OEM from Snapper and Simplicity for use in lawn tractors and snowblowers. When replacing this item a wrench will be required during the installation process. It will require replacing if it becomes stripped or broken.

Knob-int thr .312-18