5KSM150PSBWH0 KitchenAid Mixer - Parts

This part is a retaining ring, sometimes called a retaining clip, that holds the drum support roller onto the shaft of a dryer. It is made entirely of metal and measures less than an inch in diameter. The retaining ring is a genuine OEM part sourced directly from the manufacturer. The ring may vary in appearance due to manufacturer substi...Read moretution, but the function is the same. You may need to replace this part if the dryer is noisy during tumbling, will not tumble, or takes too long to dry. Be sure to check drum support roller kit and shaft before ordering parts.

Used on Stand Mixers. Sold Individually.

This worm gear is an inch and a half in diameter. It is used for some of Whirlpool's brands of mixers.

This wire whip is for stand mixers. Wire whip attaches to the beater shaft and incorporates air into cream, eggs and frostings. Follow the instructions in the owner's manual for using and installing this part.

Sold individually.

Used for Kitchenaid Mixers.

This part is used with the stand mixers attachments, as well as to hold the end cap to the front of the mixer.

Used in Mixers.

This part works in conjunction with the worm and bevel gear.

This Stand Mixer Gear Grease lubricates the moving parts of the stand mixer.

This part is used with Kitchenaid Mixers.

The speed control lever on your stand mixer allows you to adjust the speed that the mixer is running at. The lever is approximately 3.5 inches long, with a black plastic handle at the top. The speed control lever connects to the interior of your stand mixer, so you will have to take it apart to access the bar that the lever is attached to...Read more. Once you’ve opened the mixer, you can unscrew the old lever, taking care not to misplace the screw or washer that holds it in place. Replace the old lever with the new one, and then put the mixer back together.