58237 Toro Tiller - Parts

This item has been sourced from the original manufacturer and is intended to be used with snowthrowers from Toro. The metal woodruff key is used to link the motor drive shaft and the impeller pulley to allow the shaft to rotate the pulley. This woodruff key is priced as a single item.

This is an authentic replacement part manufactured for use with small engines. The metal cap is used to seal or cover the fill spout on the engine's fuel tank. This fuel tank cap is available as an individual replacement part, please see model diagram for associative parts.

This is an original replacement part manufactured for use with outdoor power equipment. The oil seal is used with a variety of different models of equipment and is commonly used to form a seal where camshaft or driveshaft exit the crankcase. This oil seal is sold as an individual replacement part, please see model diagram for associative parts.

This is an authentic OEM sourced replacement part, it is specially produced for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. This is a standard hardware which has multiple applications based on the model of your unit, please refer to appropriate diagrams for the correct and use of this item. T...Read morehis Torx screw is made of high-quality metal and it is sold individually, it includes one washer.

This is an authentic replacement part that has been sourced from the original manufacturer to be used with small engines from Briggs & Stratton and Toro. The metal screw is used to secure the muffler deflector or to secure the starter clutch to the flywheel. This item is available as an individual replacement part.

This is an authentic OEM part from Briggs and Stratton and Toro for use with garden equipment engines. The stop wire connects the ignition coil to the stop switch to ground the spark voltage to the engine block when you release the bail control bar. This part is sold individually. The tool that you will need to replace the stop wire is pliers.

This is a genuine Briggs & Stratton and Toro part sourced directly from the manufacturer for use in blowers, engines, generators, lawn tractors, and vacuums. The crankcase gasket is made out of a thin material. A wrench may be necessary during the installation of this item. It may become broken and will need to be replaced. This is available as an individual replacement part.

The screw is made of metal and attaches to the front panel. This is a genuine Toro and Lawn Boy part sourced directly from the manufacturer for use in snowblowers. Keep in mind that this item is sold individually. When replacing this part a flat head screwdriver might be required during the installation process. It might strip or break over time and will need replacing.

This replacement tank assembly is supplied directly from the original equipment manufacturer for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. The purpose of this tank is to hold the fuel which is needed for the engine, over time components may wear out or get damaged eventually requiring a replacem...Read moreent. It is a high-quality item that is made of durable metal and is sold individually.