My Orders
555M - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Mistreated Briggs & Stratton 206 CC Engine on MTD Chipper
10 of 14 people
found this instruction helpful.
-
Dana from HAMMOND, IN
- A Bit Difficult
- 1- 2 hours
-
Nutdriver, Pliers, Screw drivers, Socket set
Removed tank and drained old gas.
Removed and disassembled carb. Needed new gaskets and seals, and had to clean corn syrup glaze (separated ethanol) from bowl and everywhere else with carb cleaner.
Throttle linkage was de-plating/rusty. Steel wool and WD40 got it moving again.
Cleaned spark plug electrode.
Reassemble ... Read more d, poured Sea Foam in the bottom of the tank and gave it a few pulls.
Let Sea Foam sit for a while, then filled the tank with Premium.
Blew white smoke for a minute then ran like new. Shredded for a while, then changed the oil.
Removed and disassembled carb. Needed new gaskets and seals, and had to clean corn syrup glaze (separated ethanol) from bowl and everywhere else with carb cleaner.
Throttle linkage was de-plating/rusty. Steel wool and WD40 got it moving again.
Cleaned spark plug electrode.
Reassemble ... Read more d, poured Sea Foam in the bottom of the tank and gave it a few pulls.
Let Sea Foam sit for a while, then filled the tank with Premium.
Blew white smoke for a minute then ran like new. Shredded for a while, then changed the oil.
Read less
Was this helpful?
Thank you for voting!
replace worn PLASTIC discharge chute linkage gears
7 of 8 people
found this instruction helpful.
-
James from PLAISTOW, NH
- Easy
- 15 - 30 mins
-
Pliers, Screw drivers, Socket set
start with chute auger and punch out roll pins and cotter pin, reassemble linkage with METAL universal gears
Was this helpful?
Thank you for voting!
Installed new scrapper blade
3 of 5 people
found this instruction helpful.
-
Larry from ULYSSES, KS
- Really Easy
- Less than 15 mins
-
Pliers, Screw drivers
Unbolt old one with 4 screws and nuts and replaced new blade with new screws . Very easy fix with new blade and screws . Thanks
Was this helpful?
Thank you for voting!
Dishwasher control panel cracked when opening the dishwasher door
2 of 4 people
found this instruction helpful.
-
Freeland from KENNEBUNKPORT, ME
- Really Easy
- 15 - 30 mins
First I watched the Parts Select video (Dishwasher Control Panel (Part #00475255 - How to replace) on YouTube just to be sure I could do the replacement. I ordered the part (delivered next day) and replaced the control panel in less than 30 minutes while watching the video. One note, you should be prepared to have a small stool or box t
... Read more
o set the electrical components on while swapping the buttons on the control panel. I did not want to leave them hanging by the wires and this is not shown on the video.
Read less
Was this helpful?
Thank you for voting!