55587 Dynabrade Drill - Parts

This authentic component is supplied by the original manufacturer for use with Dynabrade power tools. Ball bearings are generally utilized to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Bearings experience c...Read moreonstant wear from pressure, heat, vibration and friction, eventually requiring a replacement to ensure top performance. Keep in mind this high-quality part is made of durable metal and is sold individually. Please make sure to check the appropriate diagrams of your model for the correct location and application of this hardware.

This is an authentic Dynabrade replacement part, sourced from the original manufacturer for use with pneumatic power tools. The gears are commonly used to link and to drive part assemblies. This gear is compatible is several different types of tools, and the application of the gear can vary based on the model of the tool. This gear is sold individually.

This is a genuine manufacturer-approved component which is designed for Dynabrade sanders and grinders. It is an identical replacement for a missing or a damaged pin that was installed on a new unit. This is one of the pins for the rear end plate. Refer to the owner's manual and the parts diagram for your model to ensure the correct repla...Read morecement procedure. Note, this high-quality pin is made of a durable metal and is sold as an individual item. A screwdriver and pliers will be needed to perform this repair.

This authentic replacement part is designed for use with Dynabrade power tools. Ball bearings are generally utilized to reduce friction between rotating parts. The rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Over time components may wear out and begin to fail ...Read moreeventually requiring a replacement, keep in mind this high-quality metal bearing is sold individually.

The bearing attaches to the bevel gear and is a part of the angle-head assembly. It is an OEM from Dynabrade for use in drills, grinders, polishers, sanders, and vacuums. This item is made of metal and is available as an individual replacement part. If this item becomes worn down it will need to be replaced and may require a wrench and a set of pliers during the installation.

This genuine OEM replacement part is used in a variety of grinders and sanders, so it is wise to cross reference your Model Number. The purpose of this is to ensure a proper fit so that your machine can run safely. The hardware required to secure this part into place will be sold separately.