My Orders
- Home
- 5553-0-C4029
- Instructions
5553-0-C4029 Briggs and Stratton Generator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Dry rotted rubber
7 of 12 people
found this instruction helpful.
-
James from PICAYUNE, MS
- Very Easy
- Less than 15 mins
Put some dish soap on the rubber, push into the tank hole, slip 1x2 into the handle of the tank and over the new part and pry down pushing it into the hole. Took about 2 minutes.
Was this helpful?
Thank you for voting!
old valve dripped gas when opened on cold sub zero day
4 of 6 people
found this instruction helpful.
-
Alan from RADFORD, VA
- A Bit Difficult
- 1- 2 hours
-
Pliers, Screw drivers
old valve easily pulled out with screwdriver and pliers
install difficult due to 40 degree cold temp and bushing didn't want to squeeze into fuel tank hole
install required lots of liquid soap on bushing, which popped into place by using upward prying pressure from 3"X24" plywood braced into under-shelf of gas tank ... Read more r />
used same technique to insert valve upward into bushing
works great!
install difficult due to 40 degree cold temp and bushing didn't want to squeeze into fuel tank hole
install required lots of liquid soap on bushing, which popped into place by using upward prying pressure from 3"X24" plywood braced into under-shelf of gas tank ... Read more r />
used same technique to insert valve upward into bushing
works great!
Read less
Was this helpful?
Thank you for voting!
major gas leak on my generator
9 of 24 people
found this instruction helpful.
-
John from LEES SUMMIT, MO
- Really Easy
- 15 - 30 mins
-
Nutdriver, Pliers
popped out the old-----the bushing failed. replaced as per the included instructions
Was this helpful?
Thank you for voting!