5329 - Parts

This is a genuine OEM sourced replacement u-tube bulb, not an aftermarket equivalent. It is specially designed for Coleman equipment. It used to provide consistent bright white light. Please note, this 13W fluorescent ligh bulb is sold individually. No special tools needed to replace this part.

This is an authentic Dynabrade replacement part. The pin is designed by the manufacturer for use in grinders, files, sanders, and drills. This part is made of metal, and is used to interact with the safety throttle lever. Please be aware that there are different pins used in the machine. Refer to the parts diagram to be sure of ordering the correct part. This item is sold individually.

This authentic replacement part is designed for use with Dynabrade power tools. Ball bearings are used to reduce friction between rotating parts. It is one of the bearings for the rotor. The rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Over time bearings may be...Read moregin to wear out compromising tools functionality and eventually requiring a replacement. This part is made from durable metal and it is sold individually.

This 3-speed wire harness is supplied by the original manufacturer for use in ceiling fans. It is an electrical component that connects the ceiling fan motor to the fan speed switch to allow the user to control the speed settings. Over time the wire harness may become faulty due to physical damage, loose connections, or electrical failure...Read mores. If it fails, you will likely be unable to adjust the speed settings, or the fan may not run at all. Before beginning this repair, turn off the power to the fan at the circuit breaker. Remove the fan blades and any other parts blocking access to the electrical components. Locate the wire harness which is connected to the fan motor and speed switch or control panel (depending on your model) and take a picture of how the wires are routed for the installation. Disconnect the wire connectors and remove the faulty harness. Position the new wire harness in the appliance and connect the wires to the appropriate terminals using the image you captured. Reassemble the fan parts. Turn on the power and test the fan speed settings to ensure that the new wire harness is functioning.