51802 Dynabrade Grinder - Parts

This retaining ring is an original part from Dynabrade. Compatible with sanders, grinders and buffers, this item is sold individually. The metal ring is often used to help secure the valve stem in the housing. A pair of pliers are helpful with making the replacement.

This authentic component is supplied by the original manufacturer for use with Dynabrade power tools. Ball bearings are generally utilized to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Bearings experience c...Read moreonstant wear from pressure, heat, vibration and friction, eventually requiring a replacement to ensure top performance. Keep in mind this high-quality part is made of durable metal and is sold individually. Please make sure to check the appropriate diagrams of your model for the correct location and application of this hardware.

This part is an OEM from Dynabrade. The metal pin is compatible with many grinder and sander devices. The pin helps to fasten the throttle lever assembly to the housing. This item is sold individually. A pair of needle nose pliers may be needed for the removal and replacement.

This is a genuine manufacturer-approved component which is designed for Dynabrade sanders and grinders. It is an identical replacement for a missing or a damaged pin that was installed on a new unit. This is one of the pins for the rear end plate. Refer to the owner's manual and the parts diagram for your model to ensure the correct repla...Read morecement procedure. Note, this high-quality pin is made of a durable metal and is sold as an individual item. A screwdriver and pliers will be needed to perform this repair.

This authentic replacement part is designed for use with Dynabrade power tools. Ball bearings are generally utilized to reduce friction between rotating parts. The rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Over time components may wear out and begin to fail ...Read moreeventually requiring a replacement, keep in mind this high-quality metal bearing is sold individually.

This replacement o-ring is an original Dynabrade part that is specially produced for use with sanders, drills and grinders. It is an authentic OEM item that has multiple uses depending on your equipment, please make sure to check appropriate diagrams for correct location and use of this o-ring. Note one durable rubber o-ring is included per order.

This is an authentic Dynabrade replacement part. The gear oil fitting is designed by the manufacturer for use in power tools such as sanders, grinders, and filers. This part is made of metal, and is placed in the gear housing to allow the injection of lubricant. You may require a screwdriver or Allen wrench when replacing this part. This item is sold individually.

This is an authentic OEM component from Dynabrade. The valve stem is constructed of durable metal, and is compatible with many sander and grinder power tools. This part assists with fastening the speed regulator into the throttle lever assembly. The valve stem is sold individually. A wrench set, screwdriver and pliers are often necessary ...Read morefor the proper replacement. Refer to the owner's manual for additional repair instructions.

This is a manufacturer sourced replacement seal. It is specially produced for use with Dynabrade sanders. This is one of the seals for the tip valve/inlet bushing. Over time seals tend to shrink and crack allowing for air leaks. At that time it should be replaced to maintain top performance. It is made out of rubber material and it is sol...Read mored individually. Replacing this item you would need a wrench to replace this item.

This an authentic Dynabrade replacement part used in buffers and sanders. The spring is used to absorb shock from the valve when tool is in use. It goes between the air control ring and the tip valve. A wrench may be needed to properly install this part. This item is available as an individual replacement part.

This is an authentic OEM component from Dynabrade. The speed regulator assembly is compatible with many grinders and sanders. This metal and plastic item secures the valve stem in the housing, managing the airflow in the device. A wrench is often helpful in making the replacement.