50469293 Frigidaire Range - Instructions

Remove vent cover then remove touch screen control panel. When you remove control panel take photo of where everything is plugged in then unplug and remove control panel. 3 door switches located next to door in a plastic chassis. Test each switch with current tester. Remove the bad switch and replace with the new one. You tube DIY helped.

First thing I dir was search YouTube for any related videos and found this one https://www.youtube.com/watch?v=uHj4H9Fdxrc, it was the exact problem my microwave was exhibiting. Once I verified the problem by troubleshooting, I removed the part and verified that the switches were working fine, the door latch assembly showed signs of wear ... Read more which was the cause of the problem. After receiving the replacement part I installed it, verified that power was restored to the unit and reassembled the microwave, works fine, hope it lasts a long time!

The diagnosis is about an hour. Coz, I need to open the control panel, got a tester, and trsted all critical parts inside the panel.
Also, replaced the fuse just to make sure its a new one. Found out it was a switch (bottom part) that control the open/close of the microwave door.

When found out the problem, the rest of t ... Read more he work is easy.

You have to be very careful because the wave guide cover is very brittle. It needs to be bent very gently in order to fit the four ends into each slot. I would highly recommend buying two just in case the first one breaks.

I thought the cover was suppose to come off from the inside of microwave. It is brand new and got bent. So I ordered a new one in case it was not working with a bend in it.

Tried to find a video specific to his model, but did not. I did the repair without removing the microwave door. Unplugged the microwave. Used a putty knife to pop out the 1st level internal plastic cover. Removed the 4 screws on the 2nd level plastic cover. Used a couple of flat-head screw drivers to pop the 2nd level cover away from ... Read more the clips holding it on until I had room to slide the old latch off. Slipped on the new latch. Popped on the 2nd level cover and 4 screws. Popped on the 1st level cover. Plugged in the microwave, worked perfect.

Just take your time and be careful not to break any of the plastic clips on the 2nd level cover. I didn't break any, but if you're to rough could see someone breaking them.