5005 - Parts

Length 8 Foot Length: 6' Gauge: 18 Wires: 2 Type: Bare Wire This power supply cord is a genuine OEM sourced replacement part. It is specially made to supply power from a standard outlet to Makita power tools. A cracked or damaged cord should be replaced before continuing to use the tool. This rubber insulated cord is sold individ...Read moreually. It comes with a rubber sleeve grommet that is not sold separately. Replacing this power supply cord you will need a screwdriver. • Remove the housing screws • Remove the the housing • Disconnect the old cord wires • Remove the old power cord • Secure the new cord in place • Connect the wires • Reassemble and test the new cord

This cord guard is a genuine Makita replacement part, and it is a direct replacement for a damaged or missing cord guard. Power tool cords undergo a lot of stress, and these cord guards help to alleviate some of that stress at the weakest point--right where the cord enters the tool. Over time cord guards will deteriorate and eventually re...Read morequire replacement. Keeping a strong cord guard on your tool will help will cord life. This cord guard is compatible with the tools listed below, but it is not guaranteed to fit any other power tools.

This part is available individually. The spring washer fits between the wing nut and the flat washer. This washer is small and will need to be replaced if it gets lost or if it breaks. It is made out of metal and no tools should be necessary when replacing this item. This is an OEM Makita part directly sourced from the manufacturer for use with saws, cutters, planers, drills, and trimmers.

This genuine replacement part is supplied from original equipment manufacturer for use with Makita circular saws. This hex washer head, also called a flange head bolt is a reverse threaded bolt and it is sold individually. Please note you would need a wrench to install/remove this bolt.

Included in Part Number 516306-1. rnThis Ball Bearing is sealed on both sides. This genuine Makita replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls re...Read moreduces friction. This reduces wear on the tool, allowing it to run smoothly. rn • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with circular saws, table saws, masonry saws, planers, demolition hammers, and angle cutters. The washer has multiple applications based on the model of the power tool. It is recommended to review your model's diagram to verify this washer's compatibility. The washer is sold individually.

This item has been sourced from the original manufacturer to be used with circular saws from Makita. The metal edge guide attaches to the saws foot or base assembly. The guide is used to measure the distance from the edge of the material being cut to the blade, to aid in making long rip cuts. This item is available as an individual replacement part.

Engineered for use in power tool motor assemblies, this sealed ball bearing helps support smooth rotation while reducing friction, noise, and wear during operation. Its precision design contributes to quieter performance and improved efficiency, making it well suited for repairing tools with rough operation or bearing noise. Ideal for rou...Read moretine maintenance or motor repairs, this bearing helps restore reliable performance and extend the service life of the tool.

Genuine Makita replacement part. This pan-head phillips screw includes a washer. It is sold individually.