4960 - Overview

This screw-type clamp, also known as a hose clamp, is made of metal and is used within various models of washers to secure the tub-to-pump hose and tub/drum of the washer. Without this clamp, the hose is vulnerable to leaking and disconnecting from the tub during the wash cycle of the washer, which can present a serious safety hazard for ...Read morethe machine and your home. Clamps can wear out and lose their tension due to excessive vibrations, mechanical damage, and normal wear and tear, all things present within a washing machine. To replace this clamp, you will first need to turn off your washer and you will need access to the lower portion of the washer chassis, which may require one or multiple screwdrivers and wrenches. Once you have access, use your screwdriver to loosen this clamp, which can then be removed and replaced with the new clamp, which will need to be tightened securely. Then you can simply reassemble the rest of the washer you originally disassembled.

Dryer elbow with a 90 degree turn. To be used for turns within 4 and a half inches.

This Weber logo is an original replacement part supplied directly from the manufacturer. It is compatible with 150+ models of Weber grills. This logo is placed on the lid of the grill. Replacing this logo will keep your machinery looking pristine. Two fasteners are included with this part.

This is a Genuine Manufacturer Sourced replacement part used on a variety of Weber Grills. This is a Metal (Aluminum) assembly used to prevent drippings and food particles from marring your deck or patio.

This is an authentic OEM sourced replacement part designed for use with Weber grills. These rails are used to hold the grease/drip funnel tray to the underside of the grill so you can slide the tray in and out for easy cleaning. This set includes two (2) aluminum bottom tray rails with four (4) screws used to mount rails. To complete this repair you will need a screwdriver.

This is an authentic kit made for the lid on Weber grills. This is a 14-part set that includes two posts, two retaining clips, and ten hex nuts. The posts are used to secure the lid to the body of the grill while allowing it to swing freely as a hinge. The ends of the posts have small holes that the retaining clips slide into to keep them in place.

This is an original Weber part manufactured for use with outdoor grills. The control panel plugs with screws fasten the control panel to the side frame. Only two plugs are required to secure the control panel, and this set will include both plugs, and two screws, please note the set is sold individually.

This replacement burner tube set is supplied directly from original equipment manufacturer. It is commonly use on Weber grills. Burners are a key component of a gas grill because, it is where the flames would rise from. They are connected to control valves. This set includes three (3) stainless steel burner tubes, one (1) carry over tube ...Read moreand the hardware to secure the burners. Replacing burners is a simple task that should only require a wrench. • Make sure gas tank is disconnected • Remove screws securing the old burners • Disconnect old burners from control valves and replace them with a new burners • Secure burners using the included hardware and • Secure the carryover tube • Connect the gas tank and test the burners

This is a Genuine Weber replacement part designed for their Grills. Kit includes: push-button igniter, gas-catcher ignition chamber, white wire, black wire, and instruction sheet. Hassle-free installation enabled by easy-to-follow instructional guide