4852 - Parts

This is a genuine manufacturer-approved component which is designed for Dynabrade sanders and grinders. It is an identical replacement for a missing or a damaged pin that was installed on a new unit. This is one of the pins for the rear end plate. Refer to the owner's manual and the parts diagram for your model to ensure the correct repla...Read morecement procedure. Note, this high-quality pin is made of a durable metal and is sold as an individual item. A screwdriver and pliers will be needed to perform this repair.

This authentic replacement part is designed for use with Dynabrade power tools. Ball bearings are generally utilized to reduce friction between rotating parts. The rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Over time components may wear out and begin to fail ...Read moreeventually requiring a replacement, keep in mind this high-quality metal bearing is sold individually.

This is an authentic Dynabrade replacement part. The gear oil fitting is designed by the manufacturer for use in power tools such as sanders, grinders, and filers. This part is made of metal, and is placed in the gear housing to allow the injection of lubricant. You may require a screwdriver or Allen wrench when replacing this part. This item is sold individually.

This genuine OEM replacement part is used in a variety of grinders and sanders, so it is wise to cross reference your Model Number. The purpose of this is to ensure a proper fit so that your machine can run safely. The hardware required to secure this part into place will be sold separately.

This an authentic Dynabrade replacement part used in buffers and sanders. The spring is used to absorb shock from the valve when tool is in use. It goes between the air control ring and the tip valve. A wrench may be needed to properly install this part. This item is available as an individual replacement part.

This is a genuine Dynabrade replacement part manufactured for use with orbital sanders, and grinders. This special valve sits in the air inlet bushing, and is supported by a spring. The valve is sold individually, please see model diagram for additional parts that are available separately.

This is a genuine replacement part sourced directly from the manufacturer. The muffler is commonly found in Dynabrade power tools such as grinders and drills. This part is made of felt, and is placed between the bronze muffler and muffler cap. You may require pliers when replacing this item. This part is sold individually.

This is an authentic Proctor Silex replacement part that is sourced from the original manufacturer for use with coffee makers. The glass and plastic carafe fits under the filter holder and is used to collect coffee as it is brewed. The carafe does not require tools to install and is sold individually.