48370 Dynabrade Grinder - Parts

This is a genuine manufacturer-approved component which is designed for Dynabrade sanders and grinders. It is an identical replacement for a missing or a damaged pin that was installed on a new unit. This is one of the pins for the rear end plate. Refer to the owner's manual and the parts diagram for your model to ensure the correct repla...Read morecement procedure. Note, this high-quality pin is made of a durable metal and is sold as an individual item. A screwdriver and pliers will be needed to perform this repair.

This is an original replacement part sourced directly from the manufacturer. The collet body is commonly found in Dynabrade die grinders. This part is made of metal, and is used to hold the collet insert. You will require a wrench when replacing this product. This item is sold as an individual replacement part.

This genuine OEM replacement part is used in a variety of grinders and sanders, so it is wise to cross reference your Model Number. The purpose of this is to ensure a proper fit so that your machine can run safely. The hardware required to secure this part into place will be sold separately.

This is a manufacturer sourced replacement seal. It is specially produced for use with Dynabrade sanders. This is one of the seals for the tip valve/inlet bushing. Over time seals tend to shrink and crack allowing for air leaks. At that time it should be replaced to maintain top performance. It is made out of rubber material and it is sol...Read mored individually. Replacing this item you would need a wrench to replace this item.

This an authentic Dynabrade replacement part used in buffers and sanders. The spring is used to absorb shock from the valve when tool is in use. It goes between the air control ring and the tip valve. A wrench may be needed to properly install this part. This item is available as an individual replacement part.

This is a genuine Dynabrade replacement part manufactured for use with orbital sanders, and grinders. This special valve sits in the air inlet bushing, and is supported by a spring. The valve is sold individually, please see model diagram for additional parts that are available separately.

This is a genuine replacement part sourced directly from the manufacturer. The muffler is commonly found in Dynabrade power tools such as grinders and drills. This part is made of felt, and is placed between the bronze muffler and muffler cap. You may require pliers when replacing this item. This part is sold individually.

This is an authentic Dynabrade replacement part. The cylinder is designed by the manufacturer for use in sanders, grinders, and buffers. This part is made of metal, and is used to house the rotor that powers the machine. You may require a wrench when replacing this part. It is advisable when removing multiple parts to keep careful tra...Read moreck of their order so they can be reassembled correctly. This item is sold individually.

These authentic OEM sourced replacement rotor blades are commonly used on Dynabrade sanders and grinders. They are attached to the rotor inside the tool pushing the air. This set includes (4) compound material blades per order. Replacing these blades you will need a set of wrenches and pliers.

This felt silencer is an OEM part direct from Dynabrade. Compatible with a variety of power tools, this component is fitted onto the shaft, between the locking ring and bearing. You may require a screwdriver or Allen wrench when replacing this part. The felt silencer is sold individually.

It is a genuine item that is supplied by the original equipment manufacturer for Dynabrade tools. This special item is utilized to provide a tight seal between connected components. Unfortunately, over time the material will wear out and it may begin to crack eventually requiring a replacement. Keep in mind this high-quality part is made ...Read moreof durable material and is sold as an individual item. Refer to the appropriate diagrams for your model to ensure the correct repair procedure.