46625 Char-Broil Grill - Parts

This item is a genuine Char-Broil replacement part that is intended to be used with outdoor gas grills. The metal rail attaches to the bottom side of the firebox and is used to mount the grease tray to catch food drippings. The left rail is priced as a single replacement part.

This genuine OEM sourced replacement part is specially designed for use with Char-Broil grills. It is secured on the regulator shaft allowing user to control the burner. Replacing this part does not require any tools, simply remove the old knob and secure the knew one on the metal shaft. This durable plastic control knob has a chrome finish. Please note, this item is sold individually.

An authentic manufacturer-sourced item that is specially designed for use with Char-Broil grills. This is one of the rails used to support the grease tray. It is a high-quality component which is made of durable metal and it is sold individually, please note the hardware to secure it is sold separately.

It is an authentic OEM part which is specially designed for Char-Broil grills. The electrode provides a spark that arcs to the main burner to ignite the gas. If the burner won't light, first clean the electrode and check that it's aligned. If the problem persists, replace the igniter electrode. This item will provide an identical replacem...Read moreent for the original part that was installed on a new unit. Refer to the diagrams of your model for the correct installation of this component. Note, one durable ceramic electrode with an attached wire is included. Replacing it is a simple task that only requires a screwdriver.

This locking caster is sourced from the original equipment manufacturer for use with outdoor grills. It consists of a wheel, with a diameter of 3 inches, and a metal bracket that allows for easy transportation and positioning. It also includes a locking mechanism that prevents unintentional movement of the grill. Over time, the caster may...Read more break, corrode, or fall out of alignment, thereby causing instability, failure of the locking system, and potential accidents. The caster will also need to be replaced if it is jammed or stripped. To replace a defective caster, prop the grill up and use a wrench or screwdriver to turn and remove the caster mounting bolt. Remove any dirt and debris in the area and align the new caster with the mounting hole. Turn the caster until it is firmly locked in place to complete the repair.

The sideburner burner goes next to the sideburner. It is an authentic OEM sourced item which is specially produced for use with Char-Broil grills. This item is available as an individual replacement part. A screwdriver may be helpful when replacing this item. This part may become broken and will need to be replaced.

This is a manufacturer sourced semi-circular temperature gauge/thermometer designed for use with Char-Broil grills. It can be used to measure temperature inside the grill and the temperature of the food. This part is made out metal and it is sold individually. Wingnut is included. Dial reads 0 - 700 degrees.

This is an authentic replacement part manufactured for use with Char-Broil outdoor grills. The rubber bumpers are used with the side burner lid to prevent damage to the self or lid. This rubber bumper is available as an individual replacement part.

This replacement batter cap is an authentic OEM item specially designed for Char-Broil grills. It is use to secure the battery in the electronic ignition module. Please note one durable plastic cap with a metal spring is included per order.

This is a genuine manufacturer supplied replacement warming rack which is specially designed for use with Char-Broil grills. It helps to keep your vegetables and breads toasty while the main course is searing on the lower deck. This is a high-quality chrome plated component which is sold individually.

This is an authentic Char-Broil replacement part. The handle end is designed by the manufacturer for use in gas grills. This part is made of metal, and is placed on the lid to provide a seat at either end of the lid handle. You may require a screwdriver or wrench when replacing this part. This item is sold individually.