466241 Char-Broil Grill - Parts

OEM Rolled Stainless Steel Emitter is sold individually. This is the emitter tray only designed to be paired with a cast iron cooking grate part 80021355. Dimensions are approx. 18-1/4 X 8-7/8" Part is 5/8" Thick. If the part is heavily rusted or damaged it needs to be replaced.

This is a genuine Char-Broil replacement part, it is sold individually. This is the part of the Grill that the flame is coming from on your Gas Grill. Depending on your grill you may have 3 or 4 of these. To connect these to your grill, place the flat side of the Burner in the rear side of the firebox in the slots provided. The front of t...Read morehe burner will connect to the Electrode W/ Wire/Collector. They will connect to the Hose Valve Regulator, and then the Control Knobs will be attached, so the flame can be controlled. This part includes one threaded pin and one cotter pins.

This genuine manufacturer sourced replacement part is specially designed for Char-Broil grills. Igniter is the part that produces the spark to ignite the burner. Features 2 input terminals and two (2) output-connector on the back for the ignition switch. Requires a AA battery (not included). Replacing this electronic ignition module is ...Read moreeasy and does not require any tools • Unplug the wires from the old ignition module • Remove old igniter and replace it with a new one from the kit • Unscrew the button that holds module to the unit • Secure new module in place • Install a battery and secure the module with the button • Connect the wires and test the unit

This is a Genuine Manufacturer Approved Control Knob used on Char-Broil Gas Grills. It helps to control your Burners. This part is made out of Plastic and it is Sold Individually. Replacing this part does not require any tools, this Knob fits over the Regulator Shaft. Please note Bezel is Sold Separately.

This is an authentic Char-Broil replacement part. The cleaning tool is found in grills. This part is made of metal, and is an accessory used to scrape debris off of the infra-red emitter. No tools are required when replacing this item. This part is sold individually.

This is a genuine OEM replacement part for a Char-Broil Outdoor Stove. The grease tray is designed to catch grease drippings from food as it cooks. Before replacing this part make sure the stove is completely cooled down to avoid any possible injury. This part is made of metal with a grey powder coat finish. It is a separately sold replacement part.

This is an authentic OEM replacement part that is supplied directly from Char-Broil for use with a gas grill. The knob is used to control the temperature and intensity of the flame. This part does not require any tools simply connects to the burner valve. This part is made of chrome and plastic and is sold separately.

This replacement part is specially designed for use with Char-Broil grills. It is an authentic OEM item, not an aftermarket equivalent. This carryover tube is used to carry the flame from one burner to another as well as supporting for the burners themselves. Over time tubes tend to rust in combination of heat and moisture requiring repla...Read morecement. Please note, this stainless steel tube is sold individually. This assembly includes two cotter pins to secure the carryover tube.

This is a genuine manufacturer sourced replacement parts designed for use with Char-Broil gas grills. The purpose of a heat tent is to direct grease and drippings away from the burner tubes. This will greatly cut down on flare ups. Tents will normally begin to rust due to the combination of heat and moisture. This item is made out of steel with porcelain coating and it is sold individually.